Fire hazards are there for any fuel, Safety systems evolve to handle them. The environmental impact would be more localized than an oil spill.
https://www.phmsa.dot.gov/sites/phmsa.dot.gov/files/2023-04/...
https://old.reddit.com/r/electricvehicles/comments/1m8wlou/e...
To power your house (or, more generally, supply vaguely sine-wave like output at a constant voltage), you need a converter that will convert DC at the battery voltage to AC at the desired voltage. If a buck converter is used, for example, the AC voltage can only ever be lower than the battery voltage. If you use a cheap square wave inverter, it’s possible that the output and input voltages must actually be equal.
A motor, though, is a highly inductive load, and large motors will and do operate from truly gnarly supply waveforms as long as the current waveform is approximately correct. Industrial VFDs (variable frequency drives) do unspeakable things involving switching a DC bus voltage across the motor via H bridges at tens of MHz, which is a horrible thing to do the the wiring between the drive and the motor if it’s not extremely short. (There are, recently, some guidelines that specific types of wire with twisted conductors, better than average insulation, and high quality shields should be used to improve tolerance of the fact that rather impressive standing waves can appear in the wiring if the wiring is a quarter wavelength or longer.). I can easily imagine designing a VFD that works just fine over a respectable range of DC input voltages by adjusting its duty cycle accordingly.
One way to think of this is that a VFD looks kind of like a buck converter where the inductor is free in the sense that it’s already right there in the motor. If it’s designed right, it will handle the battery’s full voltage range, and the inductor will still be free :)
I imagine it's not the waveform or current that matters so much, as the voltage. These motors would be powering massive blades encountering incredible resistance, so you need megavolts to move them, with an input voltage all the way down to near zero.
> H bridges at tens of MHz
Imagine the MOSFETs on this thing! Do they have something that scales up to MV? That sounds like an engineering challenge in itself.
Full disclaimer: electronics is not my wheelhouse, though I have played around with motor controllers.
Assuming two days available to charge the vessel, you'd need about 100MW continuous. Not trivial, but doable.
As far as battery fires go, sure, but a) there are already a lot of electric ferries in service so designing safe maritime battery packs isn't a new challenge and b) the alternative isn't exactly risk free either; we've seen plenty of oil spills from ships.
I can only imaging how hard it is to put out a ship fire, but is there any reason to see that the situation would be different? Bunker fuel appears to be less flammable.
Petrol cars at most marginally more likely to catch fire, if at all. They cannot catch fire by simply being submerged in a foot of water, like an EV can. They are far easier to extinguish than EVs, which are practically unextinguishable and can reignite weeks or months later. You can use a fire extinguisher on a petrol car fire if you catch it early (they are usually electrical fires). If you catch an EV fire early, your best course of action is to run away as fast as possible.
Ships are not known to be subject to fires because the types of fuel they use are not generally so volatile, and they are literally surrounded by water which can be pumped to the deck or wherever to drown any fire. Some use diesel, which is difficult to light even with a match. Others use heavy crude oil that looks like tar and would be similarly difficult to ignite accidentally. A battery fire on a ship would be a HUGE problem, as we have seen with ships carrying EVs.
I think another often-overlooked risk of EVs is the arson risk. Even if batteries are less likely to catch fire (in the first few years of use, if you baby them), a bad actor can start an unextinguishable fire by shorting out or otherwise igniting a battery pack. This is easy to do and devastating.
“An American insurer found that just 25 out of 100,000 EVs suffer fire damage.
By comparison, 1530 per 100,000 ICE cars experience fire, and hybrid vehicles suffer a much higher risk of 3475 per 100,000 .”
https://www.autocar.co.uk/car-news/electric-cars/how-much-fi...
As I said, the fact that these fires can't be extinguished is a major arson risk, as is their toxicity. Insurers will eventually have to raise their rates to cover the extreme risk posed by EVs. https://www.himarley.com/news/ev-charging-fires-are-rare-but... Storing damaged EVs safely means you need to spread them out like a hundred feet apart or something, so that one of them igniting doesn't start a whole lot of EVs on fire with toxic and inextinguishable flames. There are no solutions to these problems after having EVs on the market for several years, because it's a very hard problem to solve.
If they were all electric, all of this size, and required a full charge on arrival, you’re talking about (very roughly) 1 GW continuous power requirement for charging the ships. That’s a lot; no bones about it, but it’s not unprecedented - aluminium smelters and data centers are similarly hungry for power.
Using containerized energy that can be offloaded and charged and swapped at ports is much more efficient way to spread the cost and infrastructure and safety around the world.
There are many ports where you really don't want any form of radiation/nuclear materials available.
You power this the same way you power aluminum smelters - you have a big honking grid connection and build the generation capacity in places with more room.
Is bunker fuel energy density just that bad or is it something else? A 50kg tank of diesel can easily outperform a 200kg pack of batteries in an ev.
You can bunker anywhere, even at sea if you're willing to pay. Ships have large tanks to allow for economically advantageous bunkering at cheap and low-tax ports.
Shanghai to Los Angeles is more than double that
Shanghai to LA is probably the worst example (since the pacific ocean is basically the emptiest spot on the planet, as land/port frequency goes), but Hawaii still exists and they could recharge there.
EDIT: Seems like they mostly use imported oil, so saying "bring us a bunch of oil and we'll charge your batteries with it" seems like the ship is just burning oil with extra steps.
Los Angeles port already tries to achieve zero-emissions operations by 2030 I presume more solar could be added. And I guess some/many ports and Los Angeles specifically could use wave energy. But, again, I could very well imagine Northern Australia supply ports in Eastern Asia.
How?
A grid can do it too, but spiky 400MW loads are difficult and annoying for a utility. And the port, who would probably have to call in to schedule charging.
It's much easier to "trickle" charge a grid scale battery bank, which can then be used however the port wants whenever they want without upsetting the grid.
I wonder what the "trickle" power requirement is? Knowing next to nothing about shipyard logistics... 20MW?
It likely will depend on patterns of harbour. Like how many ships visit, what sort of distance those go. And how much of total time is spend charging some ship.
Worst case is maximum distance trips and maximum utilization that is there being ship almost always being docked. Apart from times when docked ship change.
Ports can have 10+ container ships at once and unloading one can take multiple days. You're not surprising the power company with sudden loads, you're building a big power plant at the docks and then selling power to the grid during the part of the day when the price is high and charging the ships when it's low.
These kind of infrastructure is not something you can build in 3 year. You need more than one port having that.
The battery capacity you have calculated needs about 500 shipping containers.
A large shipping vessel carries 24000 container. So make the batteries containerized, and easy to load/unload.
You could imagine pretty fast charging like this, and at some point in the near future using the same infrastructure with containerized nuclear reactors.
https://world-nuclear.org/information-library/nuclear-power-...
Even if you built one, as some people have proposed designs, it doesn't get you nuclear reactors you can just stack up on a ship or something. Containerized reactors could be convenient for getting a reactor to a remote site where it's needed but once there you'll have to provide substantial shielding for it; usually the way this is meant to be done in these proposals is digging a big hole and/or putting up earthen berms around it. And those earthen berms will be subjected to a lot of neutron radiation, so you need a plan to deal with the site after you run this reactor for any substantial amount of time; the whole site will be radioactive.
There's really no getting around this, and most of the people pitching container-sized nuclear reactors are hoping investors don't realize it. The amount of shielding that you could ever hope to place in an ISO container isn't anywhere near enough.
Nuclear submarines and aircraft carriers already exist in pretty good numbers.
And the proposal was a containerised nuclear reactor, so you're going to irradiate the surrounding containers in the process.
Nuclear submarines and aircraft carriers are completely different beasts. The reactor core is very heavily shielded, is built into the ship/boat, and is tended by a team of expert operators, and (at least in the case of US/UK subs) uses bomb-grade uranium as fuel.
1. I'm ball-parking an onboard nuclear source would take up the equivalent displacement as 20-50 containers.
You can imagine this needs solving pretty hardcore optimization problems.
How many kwh are you lifting at a time with a container? How many kwh are you pumping in the same period?
Ships deliberately use cheaper, less energy dense petroleum products (heavy fuel oil), for pretty much the inverse reasons why airplanes use kerosene.
Planes run on kerosene because it's universal enough, hard to run them on heavy fuel, and there is issue with high emission of the HFO over population centers which isn't as much of a problem in middle of sea
* a 5,000 km electric range. * 40MW continuous power requirement for a 21.5 knot cruise speed[1] for a 14000 teu container vessel: * the size and weight capacity for the batteries being the same as the fuel capacity for a 14000 teu container vessel (taking the upper figure from [2]) * the battery pack having similar gravimetric (weight) and volumetric(size) energy density as this a modern Chinese NMC EV pack[3]
The short version is that the battery vessel would require about 25,000 tonnes of batteries for a 5,000km range under those assumptions, which compares to the current fuel capacity of approximately 13,000 tonnes. Volumetrically, it's even closer - about 17,000 cubic metres, compared to about 13,000 for the bunker fuel.
Furthermore, it's worth considering just how much cargo the ship carries. One teu corresponds to about 33 cubic metres of cargo space (not counting the space taken up by the walls of the container), so the ship can carry about 462,000 cubic metres of cargo. So the additional space required to carry an additional 3,500-odd cubic metres of batteries corresponds to only about 0.8% of the ship's total cargo-carrying capacity.
I was surprised at just how doable this is, to be honest. What threw me is just how much bunker fuel ships can carry; if I'm doing the sums right, a ship like this can carry enough fuel to circumnavigate the globe a couple of times over. It may well make economic sense but it's not really necessary to have that kind of range to operate the ship safely.
[1]https://www.man-es.com/docs/default-source/marine/tools/prop... [2]https://www.freightwaves.com/news/how-many-gallons-of-fuel-d... [3]https://www.batterydesign.net/zeekr-140kwh-catl-qilin/