* https://www.mobile-solarpower.com/
* https://diysolarforum.com/
Note: You'll probably need a permit for the electrical work if it's more permanent and/or grid tied.But watch the video at https://www.mobile-solarpower.com/mobile-48v-system.html for something similar to a Goal Zero or Jackery
For those wondering, the article did discuss the safety matter of using a power outlet as an inlet. And the article also points out that while this is allowed in several countries in Europe it's not allowed in the U.S., but I suppose you could always plug appliances directly into the battery instead.
(At least, this is what electricians working with 33kV in industry in Europe do, e.g. if doing maintenance on a cable to a datacentre.)
A manual break-before-make transfer switch will do the job. Not much help if you’re not home and the mains goes out and your food spoils, though fridges will stay cold for hours if left shut, and longer if there’s a lot of thermal mass in them - try to keep most of the empty space in your fridge and freezer filled with water bottles.
The actual power coming from a balcony setup is tiny, a thousand watts ballpark. The typical house will consume the vast majority of that capacity.
Even if some flows back to the grid, it will likely be consumed by losses in the transformer and wires.
I previously had a Bluetti EB70S and while it almost did what I wanted, it could only charge from AC or Solar, but not both and didn't have a way to set desired levels.
Now I have a Bluetti Apex 300, and I can set it to charge to X% off AC during overnight off-peak rates, and never drop below Y%.
Here in Florida, I can get high output from an average panel, but there are a lot of permit issues (and rightly so, a poorly installed panel can become a severe hazard in a hurricane).
Where I lived in Michigan, there weren't many permitting or zoning issues, but I'd need 3-4x the number of panels to get usable output in the winter time.
Most truly small scale solar systems don't provide enough output/value to be worth the effort, unless you're living a very low-power lifestyle.
As an example, during one of the hurricanes that came through FL last year we lost power shortly after the storm hit. I had a smallish leak with water coming in, it was entirely manageable with a wetvac, running off my generator. But solar panels would have been producing zero output at the same time. Even a large battery bank would have been sufficient.
IME, Solar is something where there is often a case where the minimum investment to get a truly worthwhile system is higher than other things like generators, or recently even battery banks. People often overlook all the situations where solar won't produce any output. I look at solar as more of a second-tier energy independence solution than a first-tier. And it worth nothing this is speaking primarily for applications in North America that have generally stable power. If you're in a remote area with no reliable power infrastructure then the parameters are way different.
(Worth noting that during load shedding only a subset of people are turned off depending on the stage of load shedding, but on average I experienced about 25% of those totals)
..water.. ..food.. ..housing.. ..information..
I get what you are trying to conveying, I just wanted to highlight the semantic generality of the statement if it stands alone.
The well and septic system require no real effort on your part once installed, though you may find harvesting your own food to be too time consuming or labor intensive to really be actually independent.
I've lived with well water for all of my life except my college years and a few years after. In all that time, the only maintenance that's been needed has been to replace a water pressure tank (not a difficult job unless you've never seen hand tools before) and adding salt to the softener once a blue moon.
My sister in law had to get a new well put in, but that was because it needed a new well pump and the plumber she called told her he couldn't work on the existing one because it was out of code and her well wasn't grandfathered in.
Maybe you could get a bigger one if you have a large family, but I've never heard of one that would be large enough to dump that much water except for mountainside cabins that are too far from the water table for a well in the first place.
Where I am the companies charge a ‘line charge’. It’s about 20-25% of the monthly bill.
I generate somewhere between 80-110% of the power I need, but in winter I only get half what I need from solar.
A larger system would cover this and negate the need for the line charge, suddenly saving a lot.
I primarily want to generate enough solar to run my AC in the summer because that’s the dominant electricity consuming appliance in our house (except for the EV).
At least with DTE you receive credits for your production, which you can use within 12 months. So generating an excess in the summer to offset the winter is a viable strategy.
This may change with increased use of heat pumps for heating, but it’s still a while out before seasonal electricity consumption patterns invert.
+/- on what effect electric cars will have: people drive more in summer but efficiency goes down in winter.
Arizona, Florida, etc are not really in a sweet spot we all think it is because PV efficiency/output goes marginally down when it’s really hot (ie: when A/C demand peaks). Unless you install the panels at high altitude.
Ontario, just to the north of Michigan, already has a winter peak very close to the summer peak. The provinces subsidises heat pumps. Ontario will be a winter peaking region in a couple of years.
https://www.ieso.ca/power-data/demand-overview/historical-de...
Surprisingly difficult to find monthly data though :(
https://static.trinasolar.com/sites/default/files/Datasheet_...
It loses about 0.29% of (relative) power output for every degree Celsius of temperature increase. If the module is operating at its maximum rated temperature of 85 degrees C, it's still about 83% as efficient as it would be under standard test conditions (25 degrees C).
Solar farms in sunny, hot regions generate more energy per year than identical installations in cooler, less sunny regions. The benefit of extra light dominates over the efficiency loss from higher temperatures. A location with as much sunlight as Las Vegas but the temperatures of Anchorage would be ideal, but there are few if any locations with those characteristics. That's why Las Vegas is still a good location for solar farms despite the heat.
I did see some citizen science that showed a cooling fan added more power overall to panels, but I guess that’s another moving part and the way the subsidies work… who cares about increasing panel life.
No feeding of solar power to the grid so no permits.
You can add a battery if you want to reduce your reliance on the grid. Or use it with a battery but without solar panels as a whole house UPS.
If it becomes popular the slimy solar farm developers and the utility will join hands to hire a lobbyist who will ensure the rules get changed to close the loophole.
A fidge is only going to use 1.5-2kWh per day. A medium sized pergola would give you more power than that. Since you aren't opening and closing the fridge in the middle of the night, a 1 kWh battery would keep it running all day on normal days.
I did something similar with my lawn mower. I bought a battery and a single solar panel from Harbor Freight, along with the controller and wires need to hook it all together. I'd set the panel in the yard when I needed to charge the mower's batteries.
The whole thing, including the mower, cost less than half a year's fees from a yard crew, and I ended up saving money overall.
After the experiment was done (and I realized the mower was too low for my grass and was harming it) I sold the mower and gave the rest to my father-in-law for his shed.
We then got professionally installed solar panels for our house and a full-house battery. (It isn't strong enough for the air conditioner, but oh well.)
If I had it to do over again on the small scale, I'd buy an Ecoflow battery (which I have actually bought) and a solar panel made for it, and your fridge idea is a good one. It'd probably also power a fan, a light, and some light entertainment, I think.
Edit: Might go with "Anker" or "Jackery" instead of Ecoflow now, as it might be cheaper for the same thing.
I've found the sweet spot is usually in the 500-1000Wh range for emergency backup. Enough to run a fridge for 8-12 hours but not so big that the solar panel costs get crazy. The LFP (LiFePO4) models tend to last way longer than the regular lithium ones - worth the extra cost if you're planning to use it regularly.
Your lawn mower experiment sounds like it was a good learning experience! Those small Harbor Freight panels are great for tinkering. I started with something similar before going to a full house system.
So the plan I came up with is essentially the plan you have, but I connect my refrigerator to the battery by the panel rather than running an extension cord from my kitchen to the battery.
I disconnected the fridge and 2 other circuits from the panel, and terminated them with a nema 5-15p inlet receptacle like this: http://www.levitonproducts.com/catalog/model_5278-CWP.htm
I then put 4 solar panels on a 45 degree angle on the ground leaning against a south facing wall, anchored to the wall and ground.
The "solar generator" I used is this one: https://www.indiegogo.com/projects/apex-300#/
It's similar to the glamping batteries you refer to, but is more targeted to home backup / off-grid / RV use than glamping.
This will be the main issue. No matter what you're going to be doing work inside the main service panel on your house adding new feeds and you'll need to install a transfer switch to disconnect your house in case of a power outage. Most electrical work inside a panel like adding circuits will require a permit in the US. Seems like your plan doesn't involve any of that though so you should be ok permit wise except maybe needing one for the pad and structure.
If you actually want to offset cost, don't buy a portable battery pack. Get an AIO solar inverter and a server rack battery. They're generally plug and play - wire the panels to it, connect the battery.
If you want to run your home loads, the cheapest/simplest way (without going grid-tie) is to have an electrician add a critical loads panel supplied by your inverter output, then plug your inverter in to the grid for backup (in case no solar or batteries are low).
No, that's actually not the simplest.
Far simpler is to install a solar breaker in your main panel and a physical lockout[1] between utility power and the new solar breaker.
There is no ATX, there are no smarts, the power goes out and you flip two breakers. There is nothing simpler than this.
The beauty of this is, you can keep scaling up your solar generation, adding panels as the years go by, and you are never locked into these ridiculous "preferred breakers" sub-panels.
Will you have to be smart about your total power use while you are on solar ? Yes, you will - just don't run the dryer and the microwave at the same time.
[1] https://www.amazon.com/QYZZRS-Generator-Interlock-Compatible...
When I mean simplest, I meant a solution that doesn't rely on doing anything. If/when Solar isn't enough or your batteries deplete, it just falls back to grid. Power outage? Your critical items automatically are backed by solar/battery.
Having to think about your what high draw appliances are running and using additional power adds mental load (ie complexity) and is an immediate no for most people.
Cheaper way is have electrician wire a manual transfer switch at the existing panel. When you loose power, turn off non-essential breakers and then flip transfer switch.
Might as well save money and not install anything- use an extension cord for those rare times.
Our solar inverter uses the 60hz AC from and grid to do the DC->AC conversion. The inverter stops functioning if the power is out. I thought they all did that for safety.
Those home batteries mush have some solution.
https://eg4electronics.com/categories/inverters/eg4-18kpv-12...
- if you need roof repair/replacement, do it before you get solar. Alternatively, make your array free standing
- prioritize the circuits you want to cover. Not every one is critical but health & safety (water, fridge, cooking capabilities) are key
- MOST jurisdictions won't require permitting for the grid (especially if it's not connected to your house) but MOST will require an inspection if you want to connect to the grid
- if you connect to the grid, make sure you understand how your electricity provider addresses net metering. I wrote about it here: https://geekamongthetrees.com/what-is-solar-net-metering-or-...
Where I am ya don’t been a permit for a shed if it’s under a 18 square metres, so 6x3m sheds are common.
You could look in to off-grid / caravan appliances, thereby saving on a smaller inverter, but they tend to be around 3x the price of regular appliances.
Highly recommended going for 48v system if you’re starting from scratch to save on ridiculously large diameter cables and stupidly high amperage you’ll be dealing with with a 12v system.
I did a repair this week on a poorly designed 12v system that had a 12v to 230v 7amp (1600 watt) inverter powering a 230v 10amp cook top in a camper van. That cooktop was pulling 235 amp from the battery through a very hot 175amp slow blow fuse.
Which is great if you want to melt the fuse post and the supply cables and… I found the fault before the fire started.
"Zero emission generators" (aka battery boxes) are pretty easy to build, and even a 2kW inverter is relatively easy to hide/disguise. If you're doing this in a home situation (vs a camping situation) the 6V "golf cart" lead/acid batteries are really solid. A couple of those will give you 240 AHrs of 12V that can run a bunch of stuff. 240W panels can be stored at night and brought out during the day so keep them 'temporary.' Etc. Victron[1] makes nice chargers and monitors and are popular in the RV / Vanlife communities. Lots of online resources for hooking them up. And generally things you can roll around your property to different places are pretty easily defined as 'not a building' so immune from the permitting process generally.
You don't need permit, and you don't even need new wiring.
- it's sufficiently small-scale that no building permit is required
- it looks nice enough that neighbors won't complain
- the wiring is essentially plug-and-play
The best approach I've been able to come up with is to purchase a medium size battery pack such as is used for glamping (glamour camping), plug it into the wall and connect my refrigerator and a couple of other high-draw appliances to it (basement dehumidifier comes to mind), build a small roof for the back deck, using poured footings with short posts and then attaching the vertical pillars for the roof to that (which should side-step the need for a building permit since it's not a permanent structure), then placing the solar panels on that roof and running a wire to the battery placed in the kitchen.