The idea is that pedestrians, cars, etc. get a headstart so that by the time the left is legal, any people or vehicles crossing will squarely be in the middle instead of to the side where they could be blocked by a pillar.
It's also useful if you're a pedestrian going in the perpendicular direction. If your light turns yellow, you still have another 10 seconds to get across (5 seconds for the yellow->red transition, and then another 5 seconds before the opposing light turns green). Granted, this isn't universal (see below), so you still need to pay attention and sometimes hustle across.
[0] Weird that it's not all, but I still see many that turn simultaneously still.
Citation needed. Traffic laws vary widely based on the jurisdiction.
> If any pedestrian cannot get across in 5 seconds, then a change to green on the parallel vehicle traffic lane could be mistaken as absolution from liability.
No, if you hit a pedestrian in the crosswalk and they have the green, the driver would be at fault in a jurisdiction like NYC.
Also: A arrow on the signal means you can just go, a full blob means you have to be careful about other traffic.
So we have a few intersections where left turns are on a different timer, where ONLY the left turning traffic goes. Usually before the head on traffic gets green. Or where the arrow extends it for the left turning traffic, so they still are allowed to drive into the intersection when straight on wouldn't.
the parent comment is describing a scenario in which
straight (including pedestrians have green) -> straight gets red -> left gets green.
in NYC's LPIs, this is
all directions have red -> pedestrians get green -> straight + left get green with pedestrians
Regarding collisions due to people running red lights: at least when waiting to turn left chances are very good that you will see the oncoming vehicle since you're already pointed towards them.
That seems much better than being first in line at an intersection when the light turns green; in that case anyone running the light may well be coming from the side. I lived in Dallas for a few years and after a few near misses I learned to always look before proceeding after the light turns green.
Of course most drivers might do this for a week after getting their license then ignore it. Like a lot of good rules.
That's only true if there are no oncoming cars lined up to turn left in front of you. Even just one car waiting can obscure an oncoming car coming around them to run the light and crash into you as you turn.
Note that whether you have a solid green or a green arrow matters. A solid green means you can turn left, but you might have cross traffic. A green arrow means you're protected and as long as other people are obeying traffic signals, you shouldn't run into other people.
Lots of drivers don't understand this.
Lots of drivers also don't understand a red right arrow (as opposed to a red solid circle) means you cannot turn right on red. Most "no right on red" intersections have both the arrow and a sign (and many drivers ignore both).
In Washington state unprotected lefts weren't legal maneuvers for quite a while. They were introduced gradually starting at intersections where it would be a traffic benefit, for signaling the state adopted a blinking yellow arrow that then goes solid to signify the 'almost over' meaning of a typical yellow light.
But I agree with you that you should verify that no one is coming in that case; that's sound advice for most all situations, really.
This varies a lot by state. Several allow turning (after a stop) on a red arrow. Some even allow turning left on a red arrow, if it's onto a one-way street.
> Lots of drivers don't understand this.
This is logical. But, I've seen firsthand in Quebec (the city of Sherbrooke) where that's not the case. A driver may have a green arrow at the SAME TIME that a pedestrian has a walk signal. And in St. Thomas USVI I've seen opposing traffic have conflicting signals too (green arrow at same time oncoming traffic has green to go straight!)
I believe I've also seen red right turn arrows in Pennsylvania, but they don't have any special meaning there. But I couldn't say for sure.
I wonder where the driver education here is breaking down.
In PA, red arrow is just a regular red light that happens to be in a turn-only lane. All laws are the same as normal red light, the lane marking restrict your movement.
In CO, red arrow means stop and no turn on red regardless of lane markings.
Just about all traffic control laws are standardized federally except lights. That feels like the most important one to reduce confusion.
Not sure I believe this. Obviously it's a fuzzy statement but I don't think I've ever once in my life seen someone blatantly ignore oncoming traffic due to having an unprotected left signal.
I have seen that happen, though fortunately there was enough time for both drivers to avoid a crash.
This is the same in the southeast, and I assume the rest of the US.
Recently "flashing yellow" [1,2,3] has been introduced to mean left turns must yield to right of way traffic. These are gradually replacing solid green signals.
[1] https://www.txdot.gov/driver/signs-and-signals/flashing-yell...
[2] https://durhamnc.gov/1140/Flashing-Left-Turn-Arrow-Informati...
[3] https://www.penndot.gov/TravelInPA/TrafficSignalsManagement/... (PDF)
In practice that might work, but it's also a conflicting signal.
Divided roads mostly don't need left on green since they mostly have dedicated turn lanes.
Drivers must always pay attention to what's going on around them. Trying to simplify their decisions will just end up with more people getting hurt as drivers claim they had the right because the light said so.
Not that it stops pedestrians crossing whenever they like or people running reds, but it does take some of the stress out of driving.
As a driver, when you have a green light, you need to pay attention to giving priority to incoming traffic and pedestrians crossing the street, while also maintaining your calm with cars lining up behind you. It's way more intuitive that when you have a green, you can go.