I am reminded of The Vax War - https://www.hactrn.net/sra/vaxen.html
Some may recall its opening (and closing) line:
> VAXen, my children, just don't belong some places.
The story involves a VAX 750, and an IBM 3090.
The passage that will get you to start shaking you head is:
> The fire alarm klaxon went off and the siren warning of imminent halon gas release was screaming. We started to panic but the data center manager shouted over the din, ``Don't worry, the halon system failed its acceptance test last week. It's disabled and nothing will happen.''
https://en.wikipedia.org/wiki/Giga_Press
One of the largest pressing machines in the world. I think it currently presses 1/3 of the frame of a model y but they're hoping to press an entire model Y frame eventually.
https://en.m.wikipedia.org/wiki/Alcoa_50,000_ton_forging_pre...
What is special about the GigaPress die casting?
You don't get that high tolerances with casting the bigger you go. Thermal warpage needs correction, and there is only so much you can correct.
But the machine in question is used for a process much closer to injection molding than casting.
MIM is somewhat better with warpage
And a big reason they didn’t use this in the past is you’d get bubbles which reduce strength dramatically. But improvements in process tech and ability to use X-rays to do fast, non-destructive evaluation allows near-forged material properties. Better than castings of years past.
The industry after all spent a century working with it.
Aluminium alloys bring along own problems, but otherwise unbeatable on weight even if very weight inefficient methods are used, like casting.
It's a very complicated compromise even if economics is not involved.
Possibly the most extreme being chlorine triflouride, so reactive it's a better oxidiser than oxygen, as a result it can burn sand:
https://blogs.sciencemag.org/pipeline/archives/2008/02/26/sa...
https://cdn.shopify.com/s/files/1/0173/8204/7844/articles/1_...
Given the hydraulic fluid mention I was also speculating that a gigapress might be involved.
Like everyone commenting I am always amazed at exothermic events that can't be put out by water or CO2. The only one I've ever seen "in person" (other than the obligatory set some magnesium on fire in chemistry) was a halon dump on an IBM System 370 when the water coolant system burst a pipe and shorted the many bus bars. That one triggered a 15 second siren followed by a halon dump. I found it quite exciting, the plant manager, not so much.