Watts = Volts * Amps
Power lost in transmission is current through the wire times the voltage drop across the wire. The voltage drop is easy to figure out with Ohms law:
Volts = Amps * Ohms
Rewriting these with V = voltage, I = current in amps, R = resistance in ohms and P = power in Watts and simplifying one gets:
P = V * I
P = (I * R) * I
P = I**2 * R
So power losses are proportional to the square of the current flowing through any given piece of wire (that will have a resistance independent of the voltage or current).My house has 20 Amp circuits at 120 Volts. The same power transmitted at 5 volts needs 24 times the current (i.e. 480 Amps) and 24^2 times the copper in the transmission wire to have the same power losses. So I would basically need a wire with 576 times as much copper to have the same power loss in that one low voltage circuit.
This is why it isn't practical to run the whole house on low voltage. High efficiency transformers can step up or down a voltage while losing only a few percent of the power. When their output voltage is 10 times higher their output current will be 10 times smaller and can be transmitted over the same wire with only 1 percent of the original voltage's transmission power loss.
This is the reason that power transmission lines run at 120,000 volts--a million times lower transmission line losses. (It actually is a bit more complicated due to the alternating current interactions, but it's the basic idea.) Power transformers can be 99% efficient. I have no idea of the power losses that would occur between DC current from solar panels to 120 VAC and then back to 5 VDC for USB, but you definitely don't want to transmit 5VDC over long distances.
I'm still amazed that they can get 100W out of those tiny USB wires...
With how much USB cables get beat up, staying on the lower end of voltage is probably a good idea. I've definitely seen some old ones that ended up with wires exposed. But 20V is definitely more capable than the old 5V. You'd need a lot of copper to run 100W at 5V.
More info: http://www.usb.org/developers/powerdelivery/PD_1.0_Introduct...
Given a do-over on infrastructure, with today's equipment costs, it would save up front capital and power to use a small inverter at the batteries and run those items off of AC using smaller copper lines for the long run. Keep in mind that you still need DC-DC converters at the loads, since nothing is going to want to run off of your varying DC socket voltage.
(Batteries closer to the cabin is not a win, the solar panels are off that direction and those lines need to be kept short too. I do have a large inverter in the battery shed and send 120v to the cabin for big loads, but its idle current is too high to keep up for the base loads. The most expensive part of this spring's wind turbine installation (and heaviest) is the copper wire. Low voltage DC is not an answer.)
If we accepted 20 amps as the current rating, a 12v ride-on system would offer 100 / 5 * 12 -> 240 watts, which seems low, except that DC, especially if well filtered, stacks in parallel and series much more composably than AC.
The cigarette charger standard plug sucks though, and there's a limited window of opportunity to replace it.
Oh, and to address the comment on wattage, I should have made clear I don't want to eliminate AC sockets where they are needed. I'm just looking at having DC in the wall as a convenience and efficiency thing and a way to reduce the number of power adaptors I need.
I don't see it as a step forward to add an extra port to my cellphone or tablet. Lamps and small kitchen appliances don't even read data.
There's probably no mass-appeal way to satisfy both goals.
And from a whole house perspective, I keep hoping for a capacitor (storing charge directly rather than in chemical bonds) which would give me back most of the energy I had stored.
Also, USB outlets still down convert 120V AC. It'd be much better to do it in bulk at once place in the house and let devices use that
That's not entirely clear. Low-voltage DC has higher transmission losses, so converting to USB-level voltage in one central location might do quite a bit worse. Plus, you still need logic at the plug to detect how much power to supply.
The problem with these connectors is that they usually aren't designed for many plug/unplug cycles. The SATA power connector is also nearly unique in being designed for hotplugging by ensuring that the ground pins make contact first and disconnect last.
??
I was under the impression that a capacitor takes twice the amount of energy to charge than what is actually stored within it. i.e. efficiency is a maximum of 50%.
The proposal would be 48VDC (pretty standard for panels) to 120VAC 50Hz, back to 5 and 12 volt at the application, versus sending 12 and 5 volt around a house, call it 10x10 meter perimeter and pessimize the layout (some outlets go all the way around the house).
My strong sense is that the single-step conversion beats the three-step, but losses transmitting low voltage DC are substantial.
Also, I agree that the USB Power Delivery spec is a very good candidate for modern homes/vehicles.
If houses started coming with standardized low-voltage DC alongside the regular 110 AC, manufacturers could perhaps start selling CFLs and LEDs without builtin transformers. Although I'm not what voltage they actually run on internally.
There are already DC power standards used for electronics, too. Telecom equipment commonly uses -48 VDC. However, I expect that you will find that the majority of your electricity is used by motors and other appliances that run directly off of 110 VAC.
There, the possibility that a "Tesla" battery could do anything the same or better is not new, redundant and this article is just marketing hype: It's a report of an investor call, for crying out loud, not researched journalism. There is no reason to expect a lithium battery in the home would be cheaper than traditional, established lead-acid batteries.
The advantage of lithium in a car is obvious (weight, if you haven't had your coffee). In the home, weight is not a factor. Lithium would save space, but at the expense of lifetime and cost. Since cost is the only factor holding back installation now, I don't expect many people to pay even more for the privilege of a lithium home battery bank.
BTW, in reference to your expectation, a motors expert I work with says that 50% of all electricity consumed is consumed by motors. The refrigerator's compressor motor is generally the heaviest electricity consumer in the home.
A low cost space saving battery with high energy density would be pretty game changing here.
Is the building strong enough to support the weight? Space also has a cost.
It would also cost more to manufacture, transport and install big and heavy equipment, because it is big and heavy equipment.
"The main problem with gravitational storage is that it is incredibly weak compared to chemical, compressed air, or flywheel techniques (see the post on home energy storage options). For example, to get the amount of energy stored in a single AA battery, we would have to lift 100 kg (220 lb) 10 m (33 ft) to match it. To match the energy contained in a gallon of gasoline, we would have to lift 13 tons of water (3500 gallons) one kilometer high (3,280 feet)."
Supercomputers run on batteries for an entire day or more in our pockets. Powerful mobile gaming machines can be run from a USB socket. There has to be a way to cool me down in the summer without needing to cool my entire house (and watch as the cold air streams out underneath my door).
Edit: don't forget that AC is much more efficient than heating. With AC you are looking to change the temperature by at most 35 degrees and you are moving heat, so you are getting a multiplier there. With heating, you are heating from freezing or below for most places.
Its also incredibly efficient if you're using a geothermal system to pull cold out of the ground vs pushing heat into existing hot air with a compressor.
Literally every single person who commented on this has completely and 100% failed to read a single word I wrote. You're wrong, you're missing the point, and it seems like you're intentionally being obtuse.
Sorry if this sounds snappy, but I've read and re-read my original post over and over again and I'm not seeing why everyone interprets it as me telling them AC and heat isn't necessary. Things like "It would be nice to re-think the necessity of AC, as well" and "There has to be a way to cool me down in the summer without needing to cool my entire house" don't mean "turn off your climate control", they mean "let's get better climate control".
Your comment is exactly the kind of thinking that I was arguing against. Right now we need AC and heat for the entire house. Just a few years ago, we needed gasoline to power our cars and just a few decades ago we needed a dedicated room to run a calculator.
I have a coat with a battery that heats up just the coat for when I'm outside in winter. Shrink it to a normal long sleeve shirt that you would wear inside anyway. That's a start. The point is, we need heat/AC now, but are they the best we could possibly do? And is forced air the best we can do?
If you are talking about a per-room system, latency becomes an issue. If I go from my bedroom to my bathroom, how long must I be in the room until the heat comes on? Moreover, won't turning heat on/off put a lot of strain on the system? This is not convenient. It's an actively worse system than what I have now. Additionally, I'll spend much more energy heating each individual room, unless I have insulated doors and inside walls: another huge expense.
If you are talking about everyone wearing electric coats and blankets and their AC equivalents, forget about it. First, you have to carry a battery pack and charge it every so often. Second, where you used to be able to just turn up the AC a bit and wear shorts, now you have to wear a spacesuit to not suffocate in the summer.
I think HVAC could definitely use innovation, and this goes beyond the really expensive geothermal systems or high efficiency condensers. Boring things like insulation and construction materials is what's going to make a huge difference here. Buildings with good insulation and little air exchange with the outside will use significantly less energy than those with poor insulation. Heating being the #1 consumer of energy in any given house, we need to trap it inside for as long as possible. Remember, it's much easier to insulate a wall that's not moving, sitting, bend, bathing, etc. than a human.
In short, I understand what you are saying, and I think that others on here do too. I simply disagree with it.
Look at it like this: in 2006, who thought that having phone that needed to be charged every night and was crazy expensive and ridiculously fragile was a good idea? Sure, there were some people who had a Palm or a Windows Mobile phone, but they weren't very good. Just like people have hand warmers and electric blankets, which are bulky, inconvenient, and not very good. The the iPhone came along and was slightly better, but better enough that people would take it seriously. Maybe something like the Nest fits that analogy. Then suddenly with a few small tweaks and a change of public mindset, everyone is carrying a 12-hour-battery-life, $700, all-glass smartphone in their pocket, to the point where PCs are being phased out and hardly anyone has a house phone anymore.
So what you're saying is, we need mainframes and house phones, but maybe we should have cordless phones and network those mainframes together, because the problem of making a smartphone is just too hard.
So no, I don't think you understand. You know what's not convenient? Walking out the door and having my face frozen off by -30F weather. Having an AC unit in the living room where the cold air never reaches my bedroom at night. Bundling up in the winter. Sticking to the leather in the summer. You want to talk about convenience? That doesn't sound very convenient at all. That just sounds lazy, because it's what we have now. Lazy is not the same as convenient.
Do you have a cell phone, or are batteries too inconvenient? With current HVAC systems, you only have them in your house, your office, or your car. I used to have a bag phone in my car that I could plug into the cigarette lighter. But now I can take my phone anywhere. Why can't I take my HVAC anywhere?
You mention that you have a coat with electric heating. Is that literally the only "personal HVAC" product you've found?
Not sure exactly how much more efficient it is, but it sure builds character. It also helps that the winters are not too bad, and the summers are only kind of too bad.
But I guess there's no room for improvement, which is why heated seats were never invented in cars, why hand warmers were never invented, why heated jackets don't exist, why we don't have ice packs, etc. Those things would be crazy and useless.
I had been thinking of getting one of those wires you put on the pipe to keep it from freezing but it's behind a wall and very hard to get too...
I had an experimental panel in my backyard to provide power to a work shop shed. The shed was there when I purchased the property & house. About 6 months after planting a pole in the ground, behind the shed, but in view to my neighbors garnered a letter from the township where I live that basically said to remove it for being an eye sore.
Has anyone else ran into this problem?
I would look into fighting whomever told you to remove the solar panel. I thought solar panels were protected by Federal law? In my town, I couldn't put up a car shade for one day--without risking a ticket. I don't know what country you are in, but in the United States we have way to many laws. "Oh it sounds good, and doesn't effect me; let's enact a law prohibiting it."
So many people did that this very practice is now banned in the state of California.
Also, there are solar 'panels' in the shape of shingles or roof tiles that blend in much more than the 'traditional' ones.
Would you mind posting a link to the ones that look like shingles?
Talk to any telecoms workers and they will tell you amusing stories about acidents with the DC supply - the Painters shorting out the bussbars whilst decorating an Echange (Central Office) was one I remeber.
48 V might be posble but that means 2 Diferent sets of wireing.
I wonder if this would be a good time to define a standard low voltage plug for house hold use. An awful lot of modern electrical devices don't need 110VAC and end up wasting a lot of power converting AC to DC. I've seen replacements for wall sockets that combine a single AC socket with a few USB power ports. That's convenient, but USB wasn't designed as a power plug, it's just been co-opted for it. A well designed system of 24VDC or 48VDC would be a nice thing to have. Bonus points if it's a world standard. I'd also like a pony.