I'm still amazed that they can get 100W out of those tiny USB wires...
With how much USB cables get beat up, staying on the lower end of voltage is probably a good idea. I've definitely seen some old ones that ended up with wires exposed. But 20V is definitely more capable than the old 5V. You'd need a lot of copper to run 100W at 5V.
More info: http://www.usb.org/developers/powerdelivery/PD_1.0_Introduct...
Given a do-over on infrastructure, with today's equipment costs, it would save up front capital and power to use a small inverter at the batteries and run those items off of AC using smaller copper lines for the long run. Keep in mind that you still need DC-DC converters at the loads, since nothing is going to want to run off of your varying DC socket voltage.
(Batteries closer to the cabin is not a win, the solar panels are off that direction and those lines need to be kept short too. I do have a large inverter in the battery shed and send 120v to the cabin for big loads, but its idle current is too high to keep up for the base loads. The most expensive part of this spring's wind turbine installation (and heaviest) is the copper wire. Low voltage DC is not an answer.)
Watts = Volts * Amps
Power lost in transmission is current through the wire times the voltage drop across the wire. The voltage drop is easy to figure out with Ohms law:
Volts = Amps * Ohms
Rewriting these with V = voltage, I = current in amps, R = resistance in ohms and P = power in Watts and simplifying one gets:
So power losses are proportional to the square of the current flowing through any given piece of wire (that will have a resistance independent of the voltage or current).My house has 20 Amp circuits at 120 Volts. The same power transmitted at 5 volts needs 24 times the current (i.e. 480 Amps) and 24^2 times the copper in the transmission wire to have the same power losses. So I would basically need a wire with 576 times as much copper to have the same power loss in that one low voltage circuit.
This is why it isn't practical to run the whole house on low voltage. High efficiency transformers can step up or down a voltage while losing only a few percent of the power. When their output voltage is 10 times higher their output current will be 10 times smaller and can be transmitted over the same wire with only 1 percent of the original voltage's transmission power loss.
This is the reason that power transmission lines run at 120,000 volts--a million times lower transmission line losses. (It actually is a bit more complicated due to the alternating current interactions, but it's the basic idea.) Power transformers can be 99% efficient. I have no idea of the power losses that would occur between DC current from solar panels to 120 VAC and then back to 5 VDC for USB, but you definitely don't want to transmit 5VDC over long distances.