The fundamental problem is refresh rate. If you have two phones that refresh at 240Hz (the fastest I know of), and you want your frame rate to be 12 Hz, you’ll still only be getting 20 refreshes per 180 degree rotation. So your angular resolution will only be 9 degrees. Assuming you use portrait mode, that will make your outermost voxels ~5 mm arcs.

And even there, 12 Hz is probably pushing it in terms of flicker.

Yeah, well, that's not going to work. Interesting problem all the same.

For a 1 meter diameter and height cylinder at 60Hz voxel refresh and say 1mm resolution at the edge one would need the plane rotating at obviously 3600 rpm, and edge pixels switching at about 380KHz. Since rgb is nice to have that's 10 gigabit for a somewhat coarse display. Nothing impossible, but not a DIY territory yet.

I think one'd want the LEDs either on the receding or the advancing halves of the plate, depending on which is best for the cooling -- not all on the same side or on both -- that would be just a waste.

Or even just on one half of the plate, the other being just a countermass. This way cuts the bandwidth in two.

> For a 1 meter diameter and height cylinder at 60Hz voxel refresh and say 1mm resolution at the edge one would need the plane rotating at obviously 3600 rpm

The edge of such a display would also be moving at several hundred miles per hour, which creates it own whole set of problems.

Note that in your hypothetical 1m 60Hz display, the edge of the cylinder is moving at 422 miles per hour. I'm going to recommend an evacuated transparent bell jar for safety, at a minimum...

Of course it has to be evacuated and maybe filled with helium or something less viscous than air at low pressure; this has to be calculated wrt the heat rejection from the leds. Also centrifugal force shearing and tearing off components, imagine the fun.

All in all, this is what makes it interesting, no? 1x1 meter holo tank, not those tiny Voxon shakers.

I wonder if anyone has built multi-speed “layered” swept volumetric displays. For the center part, you would still just have one screen, but as you go further out, you’d have “spokes”, so that each screen only has to sweep a small angle (and roughly constant distance) during a frame, so that it rotates at lower RPM, and has to update fewer times.

You would still need a bare minimum of 1-2 kHz, and a lot of screens, and balancing every layer would be super difficult, but I don’t think anything about it is fundamentally impossible with current technology.

Not exactly sure what the details, but there high quality, commercial products that are probably doing something like this: https://voxon.co/products/

This is a sweeping display, it moves up and down rapidly with a projector beneath it. Same idea. I saw a demo once in NYC and it blew my mind.

Doesn't it have to be transparent?

Are phone screens (minus the phone etc) transparent?