You can use your car battery - though you will degrade that car battery much faster which is probably the battery you want to have better performance.
Home solar + storage adds community-level resiliency in disasters and will reduce the grid load needed for home EV charging and industrial level charging used by electric tractor trailers. It should be a major complimentary effort of governmental policy along with grid scale solar/wind, grid scale storage, and whatever load leveling we can effectively decarbonize.
Good luck getting that through our deadlocked government.
Especially since
E.g. https://signaturesolar.com/eg4-ll-lithium-battery-24v-200ah/
Perhaps 200kWh is a bit exaggerated. And yes you also need a good quality inverter for your home that synchronizes with the net, but I actually don't believe this to be expensive high tech...
Ideally I wouldn't want to put the energy I generate with solar, wind or differently back into the power net. In my country you basically give that away for free. There are reasons for that, but the most efficient way would be to use the energy yourself as much as possible.
Sure, 5kWH is enough to soften peaks and there could already be huge benefit to this. But a bit more capacity would be really nice to really safe the energy of sunny days. Reminds me if disappointing USPs that let me play Tetris for an additional 7-8 minutes before I feel like civilization has broken down completely until power comes back.
But it is only ever meaningful if you have the respective fixed voltage and it often make sense for a batteries to quickly calculate how long they should last if you know how much ampere a device draws. It could also become a sensible metric if we always talk about 120V/240V for general household appliances of course.
As a chemical battery discharges, the voltage drops, so at the same load in amps you get less watts later.
Your numbers are a little bit off though. I just googled some power bank (which is supposedly better than smartphone). It claims to provide 20 000 mAh at 5V. So it's 20 Ah at 5V or 100 Wh. I think most smartphones are around 10-20 Wh. Far from 5 kWh. But this discrepancy was already noted in other comments.
citation needed
I didn't know they could last as long as LiFePo though. Is this really true?
If this is true, why don't we just use more lead-acid batteries then?
LiFePo has a very high maximum cycle count. But after ten years, they'll die anyway. The only way that you can actually achieve a cycle count as high as the specification says is if you're cycling the battery two or three times a day, which I can believe if you're doing grid-levelling, but not if you're providing backup for your solar panels.
For lead-acid batteries, be aware of the difference between normal lead-acid, which are optimised for standby operation, and deep-cycle lead-acid, which are optimised for long life under regular cycling. Normal lead-acid batteries will die very quickly if cycled - they're designed to be charged all the time, and drawn on for very short period, like a car battery or a UPS.
Deep-cycle lead-acid batteries age by cycling, in contrast to LiFePo, which age by elapsed time. Their maximum cycle count is much lower than LiFePo, but if you're cycling them every couple of days, like in an off-grid solar project, and you're avoiding draining them below around 40%, then they can last 10 years.
So, if you want to cycle your batteries two or three times a day, then LiFePo is going to last a lot longer than Lead-Acid. But if you're cycling every couple of days and limiting the drain, then they can last about the same amount of time. It depends on the usage.
What helps with Lead-Acid is because it is that much cheaper than LiFePo, you can buy a larger capacity Lead-Acid battery for the same or less money, and then for the same performance requirements that larger battery will be drained less and at a lower rate, and therefore be less stressed and even last longer.
I think we don't use Lead-Acid as much as we do for several reasons:
1. Lead-Acid batteries have a reputation of flaking on us after a depressingly short amount of time. But that reputation has been earned from normal Lead-Acid batteries, not deep cycle ones.
2. People get scared by the lead in them, and how lead is toxic and we should be stopping using lead in everything. But really, lead in these batteries is not a danger to us, and Lead-Acid batteries are one of the best recycling success stories in the world. That lead isn't generally getting out into the environment. LiFePo batteries are much harder to recycle.
3. Electricians recommend installing expensive stuff, because then they get a bigger commission.
4. Lead-Acid are bigger and heavier for the same capacity than LiFePo. So, a LiFePo installation is going to look prettier in a nice consumer unit and be easier to install. They're heavy enough as it is.
[Citation needed]
Typically lead acid lifespan is around 10x less than lifepo4, even if kept within spec.
But in practice it's hard to keep them in spec too, shit sulphates immediately when you look at it wrong.
LiFePo is maybe 10x the lifespan of a normal Lead-Acid battery, if you're cycling it several times a day. A car battery for instance will not do very well in this test. But I'm talking about deep cycle Lead-Acid batteries, cycled every day or couple of days down to 70% capacity (so using 30%). This is a fairly typical workload if you're (for instance) using it as a backup for solar panels. Under those circumstances, the LiFePo battery will die from time elapsed probably about the same time as or maybe even earlier than the Lead-Acid battery dies from cycle count.
In that case, they cost about $413/effective kWh.
In this situation, a Lead-Acid will have the full capacity that you bought, but will age like you're using 30% of the capacity most of the time.
Still, I would've expected that ever increasing self discharge would've made them far worse in comparison since it gets worse as the batteries age and you can end up losing major amounts of charge to it. Not sure if that's not as much of a problem for flooded as it is for AGM but I haven't heard it mentioned in the rundown.
There are cheaper products, but reliability and trustworthyness is an issue. A good budget offering may decide to sell out their rep or start charging premium prices.
Budget offerings are about $250/kWh right now, or there are some for about $350 with cold weather protection.
In a few more years markets will mature a little and the price gap will be smaller.
With sodium ion the cost should drop to 50$/kWh.
I guess what might happen in a decade or so with EVs with "obsolete" batteries in the used market is that you just get a used EV and you have a powerwall and a secondary/tertiary city car.
In my experience, the big cost with home batteries are the same things that make artisinal custom designed and built homes expensive: the labor cost of the complex system design, installation and integration, and the premium charged because they are still marketed as a luxury product, not as a basic home appliance.
Why the complexity? It should be easy to install batteries on a house, right? In reality, every house has an idiosyncratic set of challenges and decisions that need to be made when integrating battery storage: What loads do you want to back up, and for how long? Where will the backup sub-panel be installed, and how can the backup circuits be routed to it? Where is a safe location for the battery and the automatic transfer switch to be installed? They are all answerable, but there is no general solution and each one is on a case-by-case basis.
And yes, this all does have to pass electrical codes (which exist for a reason), and needs sign-off by local building authorities, but they are not the main cost obstacle any more than they are for any major electrical upgrade to a house.
Take away the "luxury premium" part, and this also explains why home rooftop solar will always be much more expensive on a per-watt basis than utility scale solar (and yes, utility scale solar doesn't include the cost of transmission, as with any grid scale generation source).
Compare that to an EV, where thousands are assembled with predefined requirements, a set of inputs, in a purpose built environment (a factory).
In an ideal world, every house would be built with a standard connector (analogous to USB for phones or EV charger standards) that you could just plug a stationary storage system into. The houses would also be built to include an automatic transfer switch that islands the house during a power outage, and a smart load panel that dynamically decides what loads to back up based on battery capacity and user preferences. But right now, no such standards exist, and no house is built from the start that way, so everything is an expensive retrofit.
NEM3.0 doesn't make a battery a requirement to break even on costs, it just extends the payback time of solar without batteries by 3-5 years. It reduces the still absurdly long payback time of home battery storage somewhat, though. Only when you can sell power back to the grid with batteries at peak wholesale rates will batteries have anything like solar's payback time.
I haven't done the math yet to figure out how that variance relates to payback time for batteries, but would be a fun exercise.
Hopefully, 200-230 wh/kg LFP and 150 wh/kg sodium ion batteries should be a revelation in all use cases of batteries in the next year or so.
Tesla gets to operate at the extremes of volume, so they get to demand the best prices I would imagine, but the markup still seems astronomical in other things (like tools, home powerwalls, etc).
IMO there needs to be some governmental nudge. Battery prices (in theory) should be dropping in price such that many ICE-based tools will be fundamentally cheaper as batteries. An electric lawnmower shouldn't be more expensive than a very very dirty two stroke ICE lawnmower with the LFP/Sodium Ion that is coming to market.
But a lot of electric tool makers are using the reduced sound and superior torque abilities of electric tools as a price premium product. Things like lawnmowers and leaf blowers and snow blowers being high performance electric tools is like a "starter EV" for millions of Americans: it teaches them about recharging batteries, how EVs are better than ICEs in many ways (quieter, better torque, less smelly, no gasoline to spoil over winter) and how to deal with the annoyances (recharging).
Why the complexity? It should be easy to install batteries on a house, right? In reality, every house has an idiosyncratic set of challenges and decisions that need to be made when integrating battery storage: What loads do you want to back up, and for how long? Where will the backup sub-panel be installed, and how can the backup circuits be routed to it? Where is a safe location for the battery and the automatic transfer switch to be installed? They are all answerable, but there is no general solution and each one is on a case-by-case basis.
And yes, this all does have to meet electrical codes (which exist for a reason), and needs sign-off by local building authorities, but they are not the main cost obstacle any more than they are for any major electrical upgrade to a house.
Take away the "luxury premium" part, and this also explains why home rooftop solar will always be much more expensive on a per-watt basis than utility scale solar (and yes, utility scale solar doesn't include the cost of transmission, as with any grid scale generation source).
Compare that to an EV, where thousands are assembled with predefined requirements, a known set of inputs, all in a purpose built environment (a factory).
And even better, they come with a standard plug interface that we can use to send power back to the house or the grid! But hold on: if you want power when the grid goes down, you're going to need an islanding transfer switch and perhaps decide which loads to back up. I mean, do you really want to run your 40A jacuzzi heater or your 50A air conditioner off you car battery?
In an ideal future, every house would be built with a standard connector (analogous to USB for phones or EV charger standards) that you could just plug a stationary storage system into. The houses would also be built to include an automatic transfer switch that islands the house during a power outage, and a smart load panel that dynamically decides what loads to back up based on battery capacity and user preferences. But right now, no such standards exist, and no house is built from the start that way, so everything is an expensive retrofit.
If we reach a point where there is an actual secondary market for used EV batteries, the house battery market will start to boom. But 10+ year old batteries are still 85-90% healthy mostly, so it might take a while...
Some cars have > 100 kWh capacity. Why do I pay > 1000$ per kWh for a house battery? At some point it is cheaper to just buy a car, even if you would never drive it. A Tesla Powerwall has 13 or so kWh? Why don't they use the car battery with nearly 10 times as much capacity?
It is just unit prices that are far better for cars? Is the charge/discharge speed relevant? Is the technology different? Are the capacities for cars just fake? Preferably I would want 200kWh or more capacity for my home.