for the latter, the people I know who build and use such things always charge their batteries in an attended environment in some sort of mostly-fireproof setup. one has a small corner of their tech/hobby workbench that has a few 12" ceramic floor tiles stuck to a box like enclosure open on one side.
since lipos are damaged and degrade if held for long times at 4.2V full state of charge, it's recommended for the health of the battery to only charge it almost immediately before you want to use it. ideally you would do that while nearby and paying attention, not leaving it totally unattended.
example would be something like this
https://chinahobbyline.com/shop/detail/RcCar-22.2V(6S)/CNHLg...
the quality of the battery charger also matters. and be absolutely certain you're using the correct goal float voltage setting, charge rate in amps or C rating, etc.
https://www.racedayquads.com/collections/isdt-products/produ...
i have also heard of people who use a surplus steel ammo can (plentiful and cheap in many parts of the USA) for battery charging and lipo storage.
6S 4000mAhr is getting seriously into "do not fuck around with this" territory. they deserve to be treated like and equivalent weight of gasoline.
My quadcopters these days are mostly small to tiny. (It's been years since I flew anything above the 250g size that changes the rules here.) In the past, I've flown medium/big hexa and octocopters with 7S 5800mAhr batteries (two of them on the big Octo) Those batteries never came in my house. They are stored and charged in a besser block and concrete tile enclosure in my garage which has a direct metal vent pipe to the outside. They get transported in the car in an ammo can half full of sand, never more than two in the one can.
I've only once ever had one of those go off on me - in an ammo can while charging it at the field. Burying it with sand didn't put it out - it just happily burned away and got hot enough to distort the ammo can. I do not ever want that to happen anywhere near anything flammable that I care about.
I still have 4 of those big packs, I use them on an electric bicycle. I kinda hope that if I ever get mown down in traffic while riding it, it'll set fire to the car that nailed me...
I'm much less safety-nazi with my smaller lips batteries though. I store and charge 3 and 4S batteries in the 500 - 2200 mAhr range in my office - in metal tins with small-sh vent holes and watchable lids. I mistreat those batteries somewhat - my fastest quad can draw ~120A at full throttle on a fresh off charge pack (note that you do that for long, it's pretty much vanished straight up in about a second and a half when you do that. It's pretty much impossible to fly that one LOS, without the goggles I'd just lose it instantly.)
I will note that your average laptop has a battery between half that size and matching that size.
another interesting note is that a number of $2000-3000 (USD) gaming laptops are also equipped with 99Wh nominally rated battery packs so that they're still legal to take on an airplane. I was recently shopping for a new gaming laptop and ran into this while evaluating the specs of 11th/12th gen Intel series things from the usual Taiwanese vendors (asus, msi) and their ryzen 5xxx based offerings.
yes indeed.
I've recently been involved with the design of some fairly large 18650 and 21700 cell based battery packs for designs that closely approach the manufacturer datasheet rated maximum continuous amp draw per cell.
my main message for the people who use these is the following: "any sufficiently advanced battery in serious amount of energy storage, becomes indistinguishable from a bomb or incendiary device, if you look at it from the point of view of watt-hours stored per kilogram of mass"
When I got the machine repaired, I bought some sheet steel and it now sits on that instead of the wood floor. The case was metal, so I was lucky there. I'll only be buying metal cases for my desktops from now on.
I was very lucky I was in the room when it ignited.
Edit: the battery is .0777 Wh. If that burnt up in 10 seconds, that'd be 30 W concentrated on a square cm of skin, then distributed around the ring. I think that's a burn?
I think you would probably lose the finger.
Please correct me if I am wrong.
Are you actually using Li-ion rechargeable AA and AAA cells? Those exist, but because they put out 3.7 volts, are pretty uncommon. Almost all household rechargeable AA and AAAs are nickle metal hydride, which is a much less volatile chemistry (and puts out 1.2 volts, making it mostly drop-in compatible with alkaline cells).
Phones are charged in bedrooms overnight though. But I figure this setup is better than having random electronics charging in random places everywhere in the house.
But if you wanted to be safer from a potential fire, a metal cabinet is the simplest way to do it.
A deflagration from a lithium battery would just heat it up a bit, maybe start burning other stuff inside, but it's highly unlikely to spread beyond that as it would fizzle out due to lack of fuel (also temperature).
Manufacturing by it's nature has defects, get metal containers for your lithium charging and don't cheap out on batteries. If you have old lithium batteries from laptops, drones, etc, dispose of them at a local transfer station properly. Or at a minimum locate them in something metal that has a lid in an area where open flame would not readily catch something on fire.