There's a decent amount of mainline freight rail that was electrified 100 years ago but has since been ripped out. It turns out that electrification has a lot of operational constraints that make it a less-clearly-good proposition.
One obvious constraint is loading gauge issues--you need about another 2 feet of clearance for the wires. And if one bridge or tunnel along your entire route isn't high enough, you can't move along the double-stacked containers. You also need a lot of infrastructure for the tractive power substations, and if you don't have enough of them, you literally can't run more trains if the traffic demands it (and too many means infrastructure costs you're not benefiting from). The operational inflexibilities of electric locomotives in partially-electrified systems should have course be obvious.
That said, there are substantial benefits to having electric motors driving your wheels... which is why virtually all diesel locomotives are actually diesel-electric locomotives: electric locomotives that use a diesel generator onboard rather than hooking up to electrical catenary or third rail.
The result you can use overhead lines where safe, cheap and convenient and avoid them where they are not, like rail switching yards.
https://www.railjournal.com/regions/north-america/bnsf-and-g...
Maybe (hopefully) batteries will get better, but I wouldn't go dumping my money into electric locomotive startups just yet.
Similar to the battery-equipped dual-mode trolleybuses increasingly getting developed / deployed[0] allowing both point-charging at stops and more independence from overhead line (so trolleys can more easily be rerouted, or can serve increasingly longer sections without overhead lines).
[0] they've existed since the 30s but mostly electric / ICE
I think someone else brought up that with electrification you could also put traction motors in rail cars like is done often with commuter rail systems. And there is actually no need for the battery to be part of the locomotive either. Think old steam trains with a coal car.
I don't want that thing anywhere near a train... Or where I live.
In the decades after WW2, diesel-electric propulsion boomed, viable again after wartime shortages were over, simpler to maintain than steam, and more flexible than electric. This was well before double-stack trains got started in the 80s, but now that double-stack is widespread in the US, overhead electrification does present another operational hurdle.
From that video: 90kw/hr of battery. At peak power output of 180kw, you could run that for 30 minutes.
The ubiquitous GE Dash-9 used in freight service here in the US generates >3000kw and can run all day. They're also usually run in multiples to pull long heavy trains.
I wouldn't expect to see battery powered trains in the US anytime soon, except maybe short passenger-only lines on the east coast (which are probably viable for electrification anyway).
(It's not helpful to focus on the specifics of a proof of concept--unimportant in this discussion about what is feasible--versus the fundamental figures of merit of the technology... Unless one is prepared to make the case that the specifics are the limits of the technology.)
There are 100MW power, 100MWh energy lithium ion batteries installed already (with 1GWh on the way). There's no technical reason you couldn't have battery powered trains. The "batteries are too weak" argument is dead.
A tesla powerpack is 50kw, 210kwh, and weighs 3500lbs.
A freight train that would normally be pulled by four 3,000kw diesel electric locomotives would need 240 powerpacks, and could run for four hours before needing a full recharge. Those powerpacks would weigh 420 tons - the equivalent of say, four fully loaded freight cars, and cost around $25M (plus whatever the locomotives cost).
The diesel-electric locomotives are a couple million each, ready-to-run.
Ah hah you say, you only need the batteries between catenaries! How fast do you think you can charge those batteries? If you can charge the same as the full discharge rate, then you need 50% of your track to be electrified, and you need it every four hours (assuming you're willing to risk full discharge cycles). Trains don't move very fast, so that's pretty closely spaced. And even worse, you now need electrical infrastructure with twice the capacity - you need to charge the battery and move the train.
Sure there's no technical reason you couldn't do this, but the economics are not looking good. Batteries are too weak.
Tesla 85hw battery pack 1200 lbs.
3000 kw X 4 hours = 1200 kwh.
1200kwh/85kw*1200 = 170,000 lbs.
A GE/NS Dash 8 weighs in at about 390,000lbs
https://www.tesla.com/powerpack
Furthermore, it makes zero sense to compare "3000kw x 4 hours" since diesel electric locomotives can run for N>>>4 hours.
Furthermore, you're comparing the weight of batteries alone compared to the weight of a whole locomotive.
This is simply you reframing the conversation from using batteries to allow hybrid electric trains to use short sections of non-electrified tracks to hybrid electric trains won't work because they don't have the range of a diesel locomotive.
I'm going to put this down as you're unwilling to argue fairly and thus lost this argument.
Note that the eastern seaboard (with its bridges and tunnels and topography) is getting electrified; the long and flat midwest is not.
Here, I'll do it for you. Good Panasonic cells get about 250Wh/kg, or 0.9MJ/kg. Assume an electric-optimized locomotive would be able to achieve about half its weight in cells, with a useful energy density of 0.45MJ/kg. Assume about 1 locomotive for every 9 cars, and with each car weighing the same as each locomotive. So the whole train's effective energy density is 0.045MJ/kg.
The "rolling resistance" of a typical train is about 0.002, conservatively. That is a weight of 1 kgf has a resistance of 0.002kgf. (EDIT: This is a good assumption that works up to 60mph, the speed limit of freight trains, but at the typical low average speed of freight trains, it's actually about half that value: https://slideplayer.com/slide/4696076/15/images/12/Freight+T... )
The range is thus just: (specific energy)/((rolling resistance) * gravity) or: 0.045MJ/kg/(.002 * 9.8m/s^2) = ~2300km. https://www.google.com/search?q=0.045MJ%2Fkg%2F.002/(9.8m%2F...
That's enough to go from the center of the continental US to the coast on a single charge. (and from what I understand, 1 engine for every 9 cars is not uncommon)
If we have one engine for every 4 cars, you can now cross the continental US on a single charge. But remember, the discussion was about multiple recharges per trip, so there's WAY more battery here than you actually need.
And to just give an idea of the power available, 130 tons is a typical car laden weight. 65 tons of Panasonic cells gives you 16.25MWh of storage. Cells like that can discharge their cells about 12 minutes. Lets make it 30 minutes, conservatively. That gives a power at the cell level of 32500 kilowatts, ten times your 3000kW locomotive. Batteries are plenty powerful.
(And the cost is offset easily in fuel costs, as long as the battery is given the usage of about one full cycle at least once a week.)
You might point out energy requirements for braking and climbing hills. But remember that one of the greatest advantages of battery-electrics is regenerative braking. Most of the energy consumed in increasing elevation can be recovered on the way back down.
(As far as costs go, the battery pack should--including the price of industrial electricity and typical costs for automotive batteries at scale--pay for itself in fuel cost savings in about 500 cycle-equivalents while the cells should last at least 1000... meaning the overall added cost is potentially negative... meaning it's a market opportunity.)
And if you are proposing using batteries to reduce the amount of overhead wires you need, then the average power you need to transfer while connected to the wires increases, not decreases.
- UK conventional lines: 300 A @ 25 kV
- UK third rail network: 6800 A @ 750 V
- German conventional lines: 600 A @ 15 kV
- German high speed lines: 1500 A @ 15 kV
Until they have a good reason, the major freight railroads (BNSF/UP/CSX/NS/CN/CP/KCS) will continue to be all-diesel. Also, as emissions requirements have gotten more stringent they've moved to rebuilding older power (which gets around the current Tier-4 requirements instead of buying as much newer motive power. In fact, a number of the most recent-gen units have been stored as they're often 15% less efficient than the previous generation (Tier-3).
I do believe a move to electric with catenary is inevitable, most likely via 50KV/50HZ to allow for greater distance between substations. However it won't happen for some time until legislation mandates it.
Wouldn't it be possible to use (giant) batteries? It sounds terribly dangerous, but possible?
IIRC it was bandied back and forth but you'd only get a few hours of peak load, vs a diesel which can run at peak power for days before running out of fuel.
The USA have very long distances, unusual for other countries. A few hours are more than enough for short travels. Anyway, recharge times are irrelevant if you could change them easily.
Charging? I wrote about changing them, not charging.
It would be kinda cool to see a long train split in half , front and back taking different routes.
That happens all the time here, in Spain. Some trains from Madrid to Andalusia travels to Seville with two locomotives, one in the front, another one in the rear. Then half the train goes on to Cádiz, half to Huelva. Oh, and it's sometimes very long, forty passengers cars + 2 locom. + several restaurant cars.
I guess the same happens with other routes. It's all electric, of course. Rail here is cheap, very confortable and fast, 250 km/H in all high-speed network.
Edit: actually, now that I come to think about it, it seems most high-speed trains have locomotives in both ends. Maybe so they don't have to turn around? The splitted train could use four then.
I think that GP meant with "Skip the engine all together, and make trains fully dynamic" would be something where every single car could be autonomous and they just connect together (on the go?) for slipstream and traffic control. This is both real (segments are joined primarily for traffic control, "cars" already have their own motors etc) as it is far away (the individual cars of a segment are joined together at the factory and form a single articulated unit)
57€ for a 700 km travel is cheap compared to a car that will take x2 the time, unless you are OK with burning double the money on fuel and ignoring speed limits, of course risking fines and license suspension.
A full car will be cheaper if you ignore the cost of the car itself + maintenance and saved time. Families use to travel by car on holidays only because they need the car for short trips during the holidays, not because it's cheaper.
Buses were dirty cheap, I haven't even looked at the prices in the last twenty years, I had enough unconfortable eight hours travels when I had no alternative.
And when you start digging up the capital cost of locomotives you find they can easily absorb the cost of batteries.
More likely in the short term are electric engines, with a Diesel generator for the last mile (i.e. Bombardier TRAXX)
So putting in a battery would "just" mean swapping out the fuel tank, engine, and generator. Probably the biggest issue I could see is, the battery would have to be able to handle extremely high currents to get the consist moving. For example, https://en.wikipedia.org/wiki/EMD_SD90MAC shows a power output of up to 4.47 Megawatts at full engine speed (for the EMD 265).
So far as adding more passenger rail lines, it isn't easy. For instance, plans for HSR in California are unrealistic because you don't save any time from SF to LA unless you can go from downtown to downtown. Sure you can build track in the Central Valley, but it would be pretty hard to take enough land by eminent domain to build a track into the cities even if these people were not the most feared NIMBYs on the planet.
More passenger rail isn't really being built in the US, because the capital expenditures of doing so would be very large, and its return on investment in terms of direct monetary savings wouldn't materialize for many, many years. Since externalities aren't priced in, the responsibility for transportation is largely distributed to individuals, who make daily use of road vehicles on roads that the governments fund, and travel long-distance by commercial airlines that make use of airports that governments support.