News for hackers. Stuff that matters.
Re:Ask HN: Is it reasonable to cover your webCam? by dredmorbius on Saturday August 02, 2014 @10:10PM (#8126778)
Your problem isn't that covering your WebCam isn't a good idea (it is). It's that there's little market for a solution -- electrical, scotch, gaffer, duct, or other tape works just fine. A small scrap of paper or Post-It will keep adhesive from marring the lens. That's a $0.01 solution I doubt you could ever hope to compete with (though I hear suckers are born on an aggressive schedule).

That said, from a design perspective, I'd very much prefer that devices (laptops, desktops, tablets, phones, monitors, etc.) offered:

1. Hardware indicators of activation of media inputs: camera, microphones, etc.

2. Physical covers or switches to activate/deactivate these. My Thinkpad has a physical switch to activate the WiFi transmitter, but there's no shutter for the camera (I've seen slider doors on some devices), nor can the mic circuits be toggled by a physical control (though I can set my mixer settings via software).

Edit: But see comments elsewhere: stickers which explicitly convey a message about security/privacy and cover lenses could be an interesting angle. Much lower cost, fad/awareness appeal. Possibly even a tie-in with privacy groups (e.g., EFF, etc.). Good schwag.

Re:Ask HN: Is it reasonable to cover your webCam? by model-m on Saturday August 02, 2014 @10:27PM (#8126816)
Funny, I was thinking exactly the same thing this afternoon. The absence of physical switches for wifi/microphone/camera is probably due to a mix of lowering manufacturing cost and cutting on "my computer no work" maintenance calls, but I really would feel somewhat safer if I had them.

Fun fact: when I bought a hard drive for my computer (one of those old MFM 20 MB drives, it was the late eighties), I found it very noisy. The hard drive was internal, so I engineered a physical on-off switch by routing its power input through the otherwise unused turbo switch (remember those?) that was on my computer case. When I wanted to write in peace, I would turn the drive off, before turning the computer on, and boot from a floppy disk. I just had to be careful not to turn the drive off when it was already spinning, and I never did.

Re:Ask HN: Is it reasonable to cover your webCam? by pogue on Sunday August 03, 2014 @02:11AM (#8127221)
The Turbo switch! I had forgotten all about those. Did those actually ever have any function?
Re:Ask HN: Is it reasonable to cover your webCam? by thaumaturgy on Sunday August 03, 2014 @02:19PM (#8128672)
Yes! Years ago, processor speeds evolved slowly enough that it was practical for game developers to write all animation delays in their games something like this:

    for (i=0; i<400; i++) ;
They would test their delay value and then increase their loop count as necessary. This was a lot easier than doing clock-based delays. I'm not sure how it was on Windows/DOS at the time, but around the same era on MacOS, you couldn't even get millisecond accuracy without a lot of effort. The standard time unit on a Mac then was the tick, or 1/60th of a second, and some things didn't look too nice at tick granularity.

So this kind of time delay in games and other software was common practice. When processors did start getting significantly faster, some games became unplayable or bugged out altogether.

Along came the turbo button: it didn't actually make your computer faster, it made it slower. Because of the confusing name, the turbo button was usually rigged so that you would leave it on by default -- using your processor's manufactured clock speed -- but if you wanted to play an older game that relied on processor speed for delay timing, you would deactivate the turbo, slowing your system clock speed down to something that matched older hardware.

Re:Ask HN: Is it reasonable to cover your webCam? by dredmorbius on Monday August 04, 2014 @01:27AM (#8130471)
I suspect an example of these is the old xlander game. That's where you simulate landing a spacecraft on the moon using keyboard controls for thrusters.

Back in the 1990s I could run that on my Pentium 180 Mhz system.

Trying again ~10 years later I found that lunar gravity had increased markedly since ;-)

Re:Ask HN: Is it reasonable to cover your webCam? by moepstar on Sunday August 03, 2014 @03:48AM (#8127392)
Absolutely, it did change the clock speed of the processor (back then measured lower double-digit MHz/Megahertz).
Re:Ask HN: Is it reasonable to cover your webCam? by kubiiii on Sunday August 03, 2014 @12:46PM (#8128381)
Pretty useful to play games designed for the 8086 on a 286 or 386. Alley cat with the turbo was more like alley cat on meth.
Re:Ask HN: Is it reasonable to cover your webCam? by userbinator on Saturday August 02, 2014 @10:27PM (#8126815)
The WiFi switch on the Thinkpads is not a "hard on/off" that switches power like you think; it's actually just a signal that the processor in the card can ignore if it wants to.

On the topic of webcam covering: I agree with others that a separate cover is overly complex of a solution for such a simple problem: a sticker or other opaque material will suffice to block the lens effectively on computers that have integrated non-removable cameras. For a removable webcam, the simplest and safest solution is to unplug it, or if that is inconvenient, aim it at something of little interest like a blank wall.

Re:Ask HN: Is it reasonable to cover your webCam? by seba_dos1 on Sunday August 03, 2014 @07:14AM (#8127642)
Re:Ask HN: Is it reasonable to cover your webCam? by dredmorbius on Monday August 04, 2014 @01:25AM (#8130466)
Hah, there you go!

I find that the fact that someone's already pursued an idea tends to suggest it's at least worthwhile to do.