But now that Wikipedia is becoming more stable, I wonder if this policy is still pushed as much. My understanding is that on all articles there is an army of autistic and obsessive people who will make sure it stays clean (I mean it in a good way), so if you mess things up, it won't last long, as in, seconds.
Thermostatic valves are ambient at both sides - they expand and contract naturally with the existing temperature, so they are not motors per se, because there's no actuation beyond the temperature.
Edit: also, the actuation from the wax motor only happens while it is absorbing (or losing) heat, even if it later ends up in a steady state with no heat flux.
That's why it's a motor, like in dishwashers, not a thermostat like in e.g. greenhouse windows or radiators.
It doesn't need to be persistent, but without some way to create a state that is different than ambient, it's not a motor.
Also you seem to have a miscommunication with the person replying to you where they are talking about a spacial thermal gradient and you mean it in a temporal sense.
EDIT: the way I see it, talking about gradients here is nonsense. The wax motor works by expansion/contraction due to point temperature. No gradient is involved. Gradients are thermostat-level thinking, and even then, in the greenhouse scenario, there is no gradient to talk about, because the whole point is just to vent the heat from inside to outside when inside crosses certain absolute value of T, and the only "gradient" that matters is the assumption that outside side is less than T at all times.
things lietrally change its volume maintaining mass when its temperature changes, due to atoms moving more energetically, like something be 4x4x4 inches at 40F, but 4 1/16 x 4 1/16 x 4 1/16" at 200F
this isn't a Stirling engine with a displacer, just a sealed off piston
There are commercial thermostats where the wax element itself is both the temperature sensor and the actuator, eg Thera-100 T1002W0.
I had to replace about half of them within the first ten years of usage in our floor heating. It may have been a bad batch, but I would definitely not claim that the rarely fail. My car did not fail once during that time.
The idea is that so long as the washer is providing power the motor stays locked. But if you ever loose power within a few minutes you can open the door if you had to.
These are two separate things: thermostat will close and open based on surrounding temp., the actuator on the other hand opens and closes based on energizing a heating element that is driven by a separate thermostat.
Wax motors are pretty cool things. They rarely fail and do their job even in damp environments. I take care of my better half's hotel with approx 100 of these installed and we replace one of these once every couple of years.