[1] https://github.com/kabelincho/LG-Smart-Diagnostics-modem
All the same diagnostics you can do at the machine, the phone home service allowed a remote engineer to diagnose as well. Things like drum rpm, tilt/knock sensors, uneven balance detection. Instead of paying a human $250 to come out and press buttons, they can do it remotely.
I understand in the pessimistic age of John Deere, all remote diagnostics are bad, but that is not the case here. I was able to do all of the diagnosis myself to determine it was a bad stator and then replace it myself.
Decoding it without help would be difficult for the average consumer, but it's not an impossible task.
Do you mean by mimicking the noises themselves?
1. Hold a button while booting (pretty normal)
2. This reconfigures the circuit path of one of the LEDs so it is reverse-biased to VCC via its resistor and switches one of the microcontroller GPIOs to ADC input
3. You go to a website that plays a strobe pattern (encoding the firmware)
4. You hold that website in front of the LED till other LEDs blink, signifying a successful update
They could have done this using a photodiode, but no, they had to abuse an LED. Not many people are aware that LEDs can in a certain configuration be used to measure light.
We have a Miele washing machine and a Miele dryer. Solid machines all around even after years of use.
The usual solution here is an optical coupling of some kind - optocouplers (a box with a LED, photodiode, and air gap between them) are very common for this purpose, and are an inexpensive and effective option for digital signaling across an isolation boundary.
In this case they’ve basically built a custom optocoupler out of discrete components, which is a bit unusual, but makes sense when you consider the risk of corrosion due to water ingress at the diagnostic ports, and the need to access it while - for example - a dishwasher cycle is running.
The primary value discussed in the talk was electrical isolation since there's mains voltage in the appliance and the potential for shorts or inadequate isolation would require some kind of isolation, so a path that optically isolates the communication makes quite a bit of sense.
I'm also curious if other devices have gone this route.