Only in the sense that the L1 "peer" is the switch. As soon as the switch goes to forward the packet, if ports 2 and 3 are both sending to port 1 at 1Gbps and port 1 is a 1Gbps port, 2Gbps won't fit and something's got to give.
Ethernet has had the concept of full duplex for several decades and I have no idea what you mean by: "hybrid on each end allows the use of the same channel at the same time."
The physical electrical connections between a series of ethernet network ports (switch or end point - it doesn't matter) are mediated by CSMA.
No idea why you are mentioning radios. That's another medium.
this is absolutely hilarious.
Admittedly, I’m no networking expert but it was my understanding that most installs now use switches almost exclusively. Are you suggesting otherwise?
A quick search would seem to indicate I’m right. Do you mind elaborating on your snark?
Gigabit (and faster) is able to do full duplex without needing separate wires in each direction. That's the distinction they're making.
> The physical electrical connections between a series of ethernet network ports (switch or end point - it doesn't matter) are mediated by CSMA.
Not in a modern network, where there's no such thing as a wired collision.
> Take a single switch with n ports on it, where n>2. How do you mediate ethernet traffic without CSMA - its how the actual electrical signals are mediated?
Switches are not hubs. Switches have a separate receiver for each port, and each receiver is attached to one sender.
Usually, full duplex requires two separate channels. The introduction of a hybrid on each end allows the use of the same channel at the same time.
Some progress has been made in doing the same thing with radio links, but it's harder.
Nagle's algorithm is somewhat intertwined with the backoff timer in the sense that it prevents transmitting a packet until some condition is met. IIRC, setting the TCP_NODELAY flag will also disable the backoff timer, at least this is true in the case of TCP/IP over AX25.