This is similar to the rocket engines where the thrust nozzle and its extension are cooled by the fuel otherwise they would melt or fail structurally.
Image search for a turbine blade and you’ll understand as soon as you see it.
The reason you can’t shut the engine down or power off suddenly is because the blades and housing cool at different speeds, the clearance between the blade tips and housing is as close as possible.
To help with this, hot air from the turbine is sprayed onto the outside of the casing via a hot bleed air bypass when the ecm determines its necessary.
If you shut down suddenly the tips of the blades can contact the housing and best case rub, worst case break.
There’s another problem along these lines which really exemplifies how tight these tolerances are, on the a320, you need to do a bowed rotor procedure if you’ve been sitting with the engines off for 45 minutes before you restart. This involves turning the engine over with the apu to equalize the cooling throughout the engine because the core of the engine cools slower but there’s two shafts running through the middle. These shafts “bend” because the outside is cold but the middle is hot, they can then rub against each other ruining bearings etc.
Turbo timers are a legacy from the days when turbos were primarily oil cooled and synthetic oil wasn't common and shutting down a glowing hot turbo would tend to create sludge if done habitually.
Metals don't need to melt to fail. Increasing the temperature leads to gradual reduction of yields limits. For example, the yield stress of steel drops to 50% if it reaches around 500 degrees.
Another example: “jet fuel can’t melt steel.”
They creep. Have you seen, for instance, Blu-tac or glue fail? It doesn't go at once, but slowly, over a period of time. At high temperatures most metals (others on this thread have mentioned single-crystal blades) behave a bit like that.
Although steel is also weaker at temperatures far below its melting point, yes. A simple observation of a blacksmith at work should tell you that. And a think some new jets may be running hotter than Tm for steel now?
> The lower power setting on shutdown does what? Spin it at a low RPM so it doesn't decrease in temp too quickly?
Yup, or more relevantly evenly, although those tend to be related. Given almost all materials expand as they get hotter and contract as they cool, different cooling rates between parts -> different contraction rates -> different relative shape -> Very Bad in precision machinery.
You have to shut things down step by step, so that rigidity is supplied to the metals as the inertial forces are reduced.
A small addition to the sibling comments: Combustion temperatures in modern turbines are around 1400C, if I recall correctly, but the best nickel superalloys go up to 1050C or thereabouts (for long-term operation). To close this gap, the use of high-temperature alloys is supplemented with active cooling and ceramic coatings, as stated by GP.
What do you mean by "metals don't actually withstand temperature"? As in the raw metal would melt were it not for the cooling vanes?
'If powered down, the engine would destroy itself' - from what? Overheating?
The lower power setting on shutdown does what? Spin it at a low RPM so it doesn't decrease in temp too quickly?