But its an unfortunate fact that there are places in the US where installers that recommend heat pumps can't be found for 100 miles. It doesn't really matter if I'm technically correct about the merits of the tech in principle--if I can't find somebody to fix my system and my pipes start exploding, I've still made the wrong decision.
Also, heavy snows cause power outages in places where tree limbs fall on overhead lines. If gas outages happen... well I've never experienced one. Sure, if I lived in Norway I'd have a government that cares about updated infrastructure and I wouldn't have these problems, but since I don't, I do.
Given my local constraints, a dual-fuel system sounds pretty great.
Which are all good reasons why the market for domestic solar, batteries, and heat pumps is so hot right now. The US is no exception to this.
Most houses in Finland have a (decent) fireplace for heating in case of an electric outage.
If I lose power, my gas boiler does me no good. A boiler will use pumps (and maybe a power vent). A furnace will use a fan (and maybe a power vent).
[1] You can of course get a much larger heat pump to compensate, but that leaves the unit way over-sized for cooling loads.
In other words heat-energy should be going into cold side of the heat-pump (even at a low temperatures) at the same rate as it is coming out the hot-side at high temperatures. Reduce the heat in, and you will reduce the heat out.
My understanding is that improved low temperature performance has something to do with varying the amount of refrigerant in the loop: https://www.mitsubishicomfort.com/articles/keep-warm-this-wi...
Which I guess similarly explains a lot of weird conversations and people talking past each other where busses are concerned.
(I’m referring to normal air-to-refrigerant-to-air heat pumps. I know of a really weird system that is thoroughly American and an utter pain in the arse to replace because it’s specialized and undocumented. It’s quite loud, too, because it’s single-speed, and that single speed is waaaaay too high.)
Two solutions to this problem:
1) get a bigger/better heat pump.
2) improve you building insulation and figure out where you are losing energy.
We've been using 'reverse-cycle air-conditioners' for heating in Australia for decades. I'm puzzled as to why there is any debate at all on their use for heating. A heat-pump is far more efficient for obtaining heat than direct resistive heating using electricity.
Many houses here use no other form of heating at all. And then at the press of a button, we get cooling in summer too. What's not to like?
* I also have a heat-pump condensing clothes dryer. The overall heat thrown out into the room is extremely low. The hot-air comes out the hot-side of the heat-pump to dry the clothes. The warm-moist air then passes over the cold coils, condensing out the water from the clothes and returning the heat to the cold-side of the heat pump which then pushes that heat-energy out the hot-side, producing more hot air to complete the cycle. I've had this Miele heat-pump condensing dryer going strong since 2009 - 14 years.
For applications like commercial buildings, public swimming pools, industrial sites, etc. can (and increasingly do) definitely benefit from that kind of combination though.
I think this might eventually become a thing once science gets us far enough that there's an "obvious" refrigerant choice for most applications, but we definitely aren't there yet. There are hundreds of different kinds that perform better or worse in different applications.
AFAIK all of the big commercial systems that do multiple different types of heat transfer use water to do it, thus bypassing the entire refrigerant selection issue. Right now the most advanced we can do is VRF ("Variable Refrigerant Flow") systems that can individually select air handlers for cooling or heating (i.e. move the heat from one room to another). These are still commercial units and not really available for residential installs.
This enables your hot water heater to use the same circuit to heat water - that decreases your hot water bill to around a third, even in winter as the necessary heat isn’t taken from the indoor air but from the ground.
Meanwhile, I'm annoyed that heat pumps that dump the waste heat into the hot water cylinder aren't standard.
Seems like its still pretty low in Europe outside some northern countries. Germany is less than 2000/100000 people.
https://www.theecoexperts.co.uk/heat-pumps/top-countries
Meanwhile this link says US has a 15% adoption rate across all income groups. That seems higher than I expected.
https://energypost.eu/u-s-heat-pump-adoption-is-evenly-sprea...
Is there a better source on heat pump adoption rate in Europe and US?
??? That's excessively long. Our heat-pump dryer takes about 20-30 minutes to do one of our loads.* The dryer invariably ends up waiting for the washer to finish.
* Our loads aren't excessively tight in the machine. You have to allow room for the clothes to tumble loosely thus allowing lots of surface area for evaporation.
Obviously, if every heat pump dryer took 20-30 minutes, you would not hear complaints about that (that’s much faster than my gas dryer).
Every heat pump dryer I looked at on the home center's website is 240V. (Edit: I found one Miele on another home center that was a 15A@120V.)
(That's also why they don't seem to use electric kettles in the US commonly as is normal in 220 volt countries)
I also do want to get a heat pump dryer (it's next on the list after my recently installed heat pumper hot water system), but I don't have quite enough space in the laundry and apart from two or three wet weeks a year I'd mostly only use it to fluff up towels (which is why I don't have a dryer at all at the moment)...
You'd think costs would educate. Do people not talk about living expenses much?
There are two popular varieties:
- Ground source heat pumps. Those work pretty much anywhere; just dig below the perma frost and you are good to go on the northern tip of Canada, Alaska, Norway, or wherever. Works great, ground temperatures tend to be very stable and it actually goes up the deeper you dig.
- Air source heat pumps. The expensive ones still work okish at extreme temperatures like -25-ish degrees C. Which is a reason these are actually more popular than ground sources even in places (e.g. most of Scandinavia) that reliably get such temperatures each winter.