Modern engine monitors have given us more insight than ever into engine operation and I don’t find the engine management particularly taxing.
After initial takeoff, I’m likely to set the power (throttle, RPM, and fuel mixture) at 1000’ above the ground and not touch it again for 4 hours (when it’s time to transition to landing).
GAMI got their start selling more balanced fuel injectors, but there's only so much you can do when you squirt gas into a tube and hope that it makes it equally to all cylinders.
There's a _lot_ on the table in terms of efficiency and it puzzles me why there has been almost zero progress on this front.
The SDS EFI people claim up to a 20% fuel effiency gain by going to multipoint fuel injection on existing engines.
If you have consistent cooling (hey, guess what, those rear cylinders on an O-540 are running hotter than the fronts), you can run more timing and more compression.
More timing, more compression, less fuel = more efficiency. Basically everything I'm talking about is more cruise power efficiency!
I have GAMIs; they are one per cylinder, just like the factory injectors were, but provide closer matched air-fuel ratios. I also have per-cylinder EGT and CHT instruments and have measured less than 0.3gph spread (about 2%) between the leanest and richest cylinder. Modern cars are rarely measuring per-cylinder fuel, but rather measuring the average of half or all the cylinders and using that to adjust short and long term fuel trims.
Also, I dont know that you want to increase the compression on the hot cylinder. If anything Id run rich to make sure it doesnt knock
Can you elaborate further on this? Is this lower cognitive load because the engine is more reliable?
In the gallery here: https://cessnaowner.org/pilots-perspective-cessna-340/ The red controls are the mixture and have to be manually adjusted by the pilot, so you could potentially remove 1/3 of the controls from that area
Timing is a big one; magento fired engines have fixed timing. The engines can't remove or add timing to get more power.
Fuel ratios are determined by the pilot with current Lycoming and Continentals. Why should the pilot need to worry about this? EFI has been around for 40 years now and would help decrease the cognitive load on the pilot. Like, how many engines have cooked valves because the pilot (or student) forgot to richen the mixture before descending?
Cooling is a huge one. There are a few liquid cooled aircraft engines and they just make everything easier. The engines are more reliable, and it also removes a carbon monoxide poisoning risk due to corrosion in the exhaust cuff.
Yeah, a Cessna can get better fuel economy than a car traveling at 140mph but it could be _so much better_ than what it is. And not just better fuel economy, but better all around experience for the pilots (lower cognitive load), and owners (lower cost of living, more reliable engines).