News for hackers. Stuff that matters.
Re:New York City bans natural gas in new buildings by endisneigh on Saturday December 25, 2021 @07:23PM (#29688417)
My calculations were not talking about the usage of electricity, but the breakers the panels require. Hyper-heat models require 50 amp breakers and are 230V. Peak load usually only happens when the compressors cycle. The actual non-peak usage isn't that high as you've stated. Regardless the breakers must accommodate peak-load.
Re:New York City bans natural gas in new buildings by briHass on Saturday December 25, 2021 @08:48PM (#29688943)
The breaker size almost never matters in a circuit, including ac/heat pumps. These units are rated in MOCP (max overcurrent protection, aka, the breaker size) and MCA (minimum circuit ampacity, aka, what gauge wire to run.) You actually want to look up your unit's RLA (running load amps) which is what it's likely to max pull most of the time.

I'm assuming you're talking about a 4 ton multi-zone unit (which is pretty large). Those call for a 50A MOCP, but in reality, they only draw like 20A while running, plus a couple for the indoor units' fans.

Re:New York City bans natural gas in new buildings by endisneigh on Saturday December 25, 2021 @09:41PM (#29689180)
The peak load for the hyper heat units I describe do require a 50 amp breaker. Breakers depend on peak load, not average.
Re:New York City bans natural gas in new buildings by ikiris on Saturday December 25, 2021 @09:59PM (#29689269)
And again, that doesn't matter because that's for inrush current for starting the motors, and not a steady state draw.
Re:New York City bans natural gas in new buildings by endisneigh on Saturday December 25, 2021 @10:30PM (#29689409)
It does matter because my comment was talking about breakers in a typical house electrical panel.

The breaker needs to be able to handle the peak, not the average. Just go Google Mitsubishi hyper heat - it clearly states 50 amps per condenser.

I’m not sure what’s difficult to understand about this.

Re:New York City bans natural gas in new buildings by lixtra on Saturday December 25, 2021 @11:29PM (#29689681)
> Just go Google

> I’m not sure what’s difficult to understand about this.

Of course you may expect the casual reader to do the googling themselves. But if you want to make your arguments heard, it’s helpful to put a link to an authoritative source. Of course this is also true for anyone making the counter claim.

Re:New York City bans natural gas in new buildings by endisneigh on Saturday December 25, 2021 @11:33PM (#29689705)
https://www.google.com/search?q=mitsubishi+hyper+heat+ampera...

Of course the Google link has nothing to do with my claim anyway, since my original post supposed that 50 amps was required by breaker.

Re:New York City bans natural gas in new buildings by xxs on Sunday December 26, 2021 @06:06AM (#29691421)
Every single heap pump that I have heard of - has a slow start (triac based usually) module. Also the breakers should be type C (not B).

I wonder if having higher voltages in the US might be adopted for higher power devices. 110-120V is just too low, including for car charging.

Re:New York City bans natural gas in new buildings by midasuni on Sunday December 26, 2021 @07:22AM (#29691849)
My understanding from technology connections is that US circuits are 230ish volts, but it’s often centre tapped out to sockets.

I can’t imagine a permanent high energy install like a heater, shower, car charger, oven or heat pump would be 110v. If you plug in via a standard socket in europe you get about 3kW, which given european driving is probably fine overnight, but you’d want more than that in the US

Re:New York City bans natural gas in new buildings by briHass on Sunday December 26, 2021 @09:01AM (#29692401)
That's right. All power-hungry appliances (those that produce heat, mostly) get their own 240V circuit at amps typically ranging from 20-50. Electric dryers and water heaters usually get 30A @ 240V, stoves get 40A-50A @ 240V, and AC/heat pump units depend on size, but usually 30A+ @ 240V.

It's really just our basic receptacles that are 15A or 20A @ 120V. This is plenty for 99.9% of uses, with the exception of some kitchen appliances that produce heat (e.g. a plug-in kettle.) If you bought a unit that required higher voltages and was rated for use in the US, you could always have an electrician wire a 240V circuit with one of the standard 240V receptacle types.

Re:New York City bans natural gas in new buildings by midasuni on Monday December 27, 2021 @05:58AM (#29701379)
30A/7kW for a dryer? Wow how large are they and how long does it take to dry?

My oven is on a dedicated 30A circuit, but the dryer, washer, dishwasher, microwave, kettle are all on the same 32A circuit with individual 13A plugs and don’t trip it.

Re:New York City bans natural gas in new buildings by xxs on Sunday December 26, 2021 @07:49AM (#29692005)
>My understanding from technology connections is that US circuits are 230ish volts, but it’s often centre tapped out to sockets.

Indeed.

My heat pump is 3phase 230v/16A one, that's 11kW peak power, the pump itself is 5kW, though with the rest being a resistive heater. Car charging is similar as well 3phase is quite standard nowadays.

My understanding is that the US power supply is pretty similar to the one in Europe when it comes to delivery, and industrial equipment runs 3phase, 240v - something you can find at a lot (most new) homes in Europe.

Re:New York City bans natural gas in new buildings by drusenko on Saturday December 25, 2021 @07:59PM (#29688628)
Yes, electrifying everything will result in more peak demand which will require upgrading many house’s main panels. It’s not an insurmountable challenge though, especially relative to dealing with the effects of 2+ degrees of warming.
Re:New York City bans natural gas in new buildings by endisneigh on Saturday December 25, 2021 @08:03PM (#29688658)
You're missing my point - in the context of the article the issue is not upgrading the panels, it would be replacing the entire current electrical infrastructure. I'm not claiming it's insurmountable. The point is that these changes will increase the cost of housing, which will make people sprawl, the very same sprawl that will decrease the efficiency of the very same things we're talking about.

There's a political, economic and cultural balance to be struck here, technology changes notwithstanding.

Re:New York City bans natural gas in new buildings by drusenko on Sunday December 26, 2021 @01:45AM (#29690318)
A fully electrified home actually reduces overall system cost through 1- higher efficiency of electric appliances and heat pumps than their gas counterparts, and 2- a significantly reduced infrastructure cost to no longer having to maintain gas infrastructure, the totality of which (scouting, mining, transportation, last mile) is incredibly expensive. In fact, for new construction, it is often cheaper out the gate to go all electric and the efficiency savings in terms of lower electric+gas bills are significant and pure upside.

Moving on to electric retrofits, they are expensive but not crazy expensive. On the order of $2500-7500 per SFH to wire 220/30-50 amp circuits to the right places (HVAC, stove, water heater, clothes dryer, EV charger) and maybe upgrade the main panel - a far cry from redoing the entire wiring. It’s not an insane proposition to think we could retrofit all existing housing stock in a 15 year period if we wanted to take it seriously. We are going to need more electricians though.

Do you know what is actually really expensive? Billions or trillions of dollars in climate disaster losses and mitigation which we are seeing ramp up very quickly. If we continue burning fossil fuels even remotely like we are now, in 20 years time the losses we say today will look like peanuts in comparison.

Buildings make up a very significant amount of the CO2e emissions (depending on the location, often tied #1 with transportation) so doing nothing here is not really an option.

Re:New York City bans natural gas in new buildings by endisneigh on Sunday December 26, 2021 @01:57AM (#29690356)
The efficiency increase for all electric appliances except for heat pumps is generally not worth the conversion cost. Gas infrastructure is already in place so the expense is irrelevant.

If what you were saying were true then economic forces would already have led to dominance of full electric without the need for government mandates to begin with.

Re:New York City bans natural gas in new buildings by drusenko on Sunday December 26, 2021 @02:31AM (#29690472)
That’s not really true. New high efficiency heat pump water heaters - as one example - often have a 1-2 year ROI, which is pretty dramatic. HVAC is actually often the most expensive from an ROI standpoint because of larger upfront costs.

Market forces will lead us down this path eventually but they are not instantaneous, and we don’t have much time to wait. Policy can help 1- accelerate, 2- bootstrap emerging markets (eg creating demand for more induction stoves turns that market from a niche to mainstream, with more competition, more choice, and reduced cost, all of which will serve to boost demand) and 3- finance infrastructure investments that may be beyond reach for many.

On gas infrastructure, yes it is in place but it still requires significant ongoing maintenance costs which would be eliminated if it was shut down.