My "in case of power failure" phone is an old red Bell System desk phone with rotary dial. Still works great.
Edit: Just realized why a zero is in the '10' position on a rotary phone. Huh.
This is why the emergency number in NZ is 111, we had equipment from the UK, where the number was 999.
As to why it was backwards, I have no idea.
Technically, the network gives it a priority, and you can make a 112 call even without a SIM card, or even if your operator does not have coverage. The call goes through any operator that has coverage. (You can actually see this in the phone display when making a 112 call; it handles it quite differently. I have done it a few times; unfortunately, most of those times, someone has died...)
If the network is so busy that all traffic channels in GSM are occupied, and you make a 112 call, one of the existing calls is dropped and you get the emergency call.
This had some interesting side effects in China. There, prior to introduction of GSM, the number 112 was allocated to phone company technical complaints. Police was 110 and fire alarm was 119 and so on.
So, if you were making a GSM phone call to a friend, and the network was full - not that infrequent in China - you wouldn't get through. But you could call the technical complaint line at 112, and this was a priority service which dropped one of the existing calls. Once the technical complaint service was ringing, you could drop that call (to the network, an emergency call) and you'd have one free GSM time slot in your cell. And you could call your friend.
Until the next guy did the same, and your ongoing call would get mysteriously dropped.
I did it once, the quality was rather lacking, since it used amplitude modulation instead of frequency modulation.
Here's an instructable on it: http://www.instructables.com/id/How-to-Send-Sound-using-a-La...
It's not quite what you're asking, but it's probably the closest you can feasibly get. I'm fairly sure that's also the way that laser microphones work as well.
I have not tried using a motor as a mic.
Wouldn't the efficiencies between input/output transducers be inverse? A servo drive transducer would use very little energy to produce a lot of acoustic output, so wouldn't it require a large amount of acoustic input to generate any signal at all?
But that sounds like a fun trick!
I had a MacGyver moment in the past where I made a phone call with only are pair of old earbuds and a phone cord (no switches, no dial pad).
A speaker is basically the same thing as a microphone in reverse. Normally it takes an electrical signal to move a physical element that creates the sound waves. But you can also move the element and it will generate an electrical signal.
To dial you can use the old rotary trick. The old phones dialed by pulses of quickly disconnecting and reconnecting. You can do that by hand if you want but it might require a little bit of practice and dexterity. Basically if you want to dial a 5, just disconnect the wire from the headphone to the phone cord and then reconnect it 5 times in a row.
You have to both listen and speak through the ear bud. Not the best quality or easiest to do but it works.