Re:Devastating Amazon hardware review of a wireless power sw...
by nfriedly on Friday July 01, 2016 @10:05AM
(#12016073)
Incidentally, I reviewed a pre-release version of that device a few months back. I didn't try flashing custom firmware to it though - are there any instructions for that that I could link to from the review?
http://www.nfriedly.com/techblog/2015-12-16-itead-sonoff-sla...
Re:Devastating Amazon hardware review of a wireless power sw...
by StavrosK on Friday July 01, 2016 @11:58AM
(#12017203)
It looks like you connect 3.3V/GND/TX/RX to the four pins shown in this image:
http://dl.itead.cc/IM151116002/sonoff-parts-without-433.jpg
Then you flash it with PlatformIO as usual, except I'm not sure which pins are connected where, that would take some fiddling. I'll buy one to experiment with.
Re:Devastating Amazon hardware review of a wireless power sw...
by StavrosK on Friday July 01, 2016 @11:54AM
(#12017162)
Ooooh, fantastic! Do you know where to connect the FTDI? I see that they're using a bare ESP8266 instead of a 12E.
EDIT: Looks like they even expose serial connection pins. It should be pretty easy to figure out which pin the relay is on and which the button is on.
It has the same configuration problems he mentioned but is easily flashable via FTDI.