The kind of butler robot we can make today [3] would seem extremely expensive for the functionality it could offer, making it hard get the sales needed to recoup your up front engineering costs - let alone to achieve the economies of scale needed to bring down the price on those sensors.
[1] http://www.robotshop.com/en/hokuyo-urg-04lx-ug01-scanning-la... [2] http://www.newark.com/xsens/mti-20-2a5g4/mems-module-3d-moti... [3] https://www.youtube.com/watch?v=tODGHw8uNnY
It's a lot cheaper than it used to be. When we did our DARPA Grand Challenge vehicle ten years ago, we had about 3 degrees of heading noise, which kept the system which integrated LIDAR data into a terrain map from reliably mapping. The system had a MEMS gyro with too high a drift rate, and a magnetometer compass for long-term correction. But there were enough magnetic fields from the onboard equipment to mess up the magnetic compass. The software could detect trouble, and would stop, tilt the laser head to scan the terrain ahead and get a clean image, then advance. So the vehicle kept stopping to rescan.
We looked into better heading gyros, but they cost about $20K at the time.
Applications for IMUs include dead reckoning (working out your position based on rotation and acceleration measurements), orientation sensing (figuring out which way is down is much easier than dead reckoning, because you can just sense gravity), and compensating sensor readings for robot motion.
Some cheap sensors aren't very precise; you won't notice if your phone thinks it's rotating two degrees a minute around the vertical axis, but a robot will if it moves for five minutes then it's ten degrees off course. I haven't looked at the market for a long time - I suspect the cheaper IMUs are better nowerdays. Eight years ago they didn't offer very good precision and the open source software could be very fiddly to get working, if you could get it working at all.
The OXTS RT3000 has impressive specs - 1cm accuracy in world coordinates. That's better than you need for most robotics applications that aren't running blind. The Trimble AP10 [2] has the same functionality at much lower cost, but is not as accurate.
A lot of progress in robotics comes from component improvement like this. There was a time when just getting a wireless data link to your robot was a big deal.
[1] http://www.analog.com/en/products/mems/mems-gyroscopes/adxrs... [2] http://www.trimble.com/gnss-inertial/AP10.aspx?dtID
I basically have zero confidence that we'll see something like what you are describing in next 2 decades atleast.
Consumer robotics doesn't have much of an entry barrier but as other have pointed out the components you need mean that prices are going to be in the $X0,000 range. That's too much for consumers but I think we're going to be seeing robots in warehouses soon.
If I were a car manufacturer and nobody wanted to buy my cars because they were seen as dangerous, I might try to make my cars safer to increase my sales, even if the law didn't require it.
Because the line of how much is too much is indistinct, someone is going to guess wrong before too long. This is even before you mix in perverse organizational incentives involving short-term view or individual profit vs long-term company health.
But as someone else said, that's probably the step associated with doing laundry that's the least effort. Putting clothes away is the biggest effort and good luck designing a robot to handle that.
It's interesting when I meet people I can smell who has left their clothes in the washer too long.
(And yes I realize these tasks involve surprisingly hard AI problems, but why isn't Google already running pilots where they give people special washing machines, laundry machines, robot-friendly book shelves, etc etc that help mitigate the hard AI aspects of the problem?)