(But you'd also find this spilling over into 3rd party hardware: My HD controller for my Amiga 2000 back in the day had a Z80 on it.
That machine was totally schizophrenic: In addition to the 6502 core on the keyboard, the M68k main CPU and the Z80 on the HD controller it also had an x86 on a bridge board - the A2000 had both Amiga-style Zorro slots and ISA slots, including one slot where both connectors were in line where you could slot in a "bridge board" with an 8086 that effectively gave you a PC inside your Amiga, with the display available in a window on the Amiga desktop).
The CPU was less powerful than any of the x86 32bit chips that were widely available at the time, but as a kid it still really gave me the idea that whatever I could think of, I could make a computer do.
I'd agree, understanding things at a really basic level first helped me to better understand things at a higher level later on. It probably helps me to keep in mind what a computer actually needs to do to run code as well. I think it's probably one of the reasons Knuth uses MIX in TAOCP.
I'd say with the older ones. With those, you can put a logic analyzer on the memory bus and see what's going on - if the pins aren't on a BGA under the chip and the board has no vias.
To work with them is to teach bad habits and useless skills.
It's not that they don't have craziness, it's that the functionality that mere mortals need to use to write efficient code is simpler.
The M68k's 8 general purpose data registers and 8 general purpose address registers alone is sufficient to make a huge difference.
For me, moving to an x86 machine was what made me give up assembler - in disgust - and it is something I've heard many times over the years: it takes a special kind of masochist to program x86 assembly; for a lot of people who grew up with other architectures, it's one step too far into insanity.
The regularity of the 6502's instruction set is a partially a consequence of using a PLA for instruction decoding. If you can decode a bunch of instructions with a simple bit pattern, it saves space.
But secondly, where the 6502 deviates from a tiny set of regular patterns it is largely by omitting specific forms of instructions, either because the variation would make no sense, or to save space - the beauty of the 6502 is how simple it is:
You can fit the 6502 instruction set on a single sheet of paper with sufficient detail that someone with some asm exposure could understand most of it.
http://www.mcuic.com/bookpic/200811516244620817.pdf
(Look at page 9. This IC is found in a lot of generic mouses.)
(That "one exception" was the TI-84 Keyboard for the original Nspire, which did run the 84's firmware in a Z80 emulator on the Nspire's ARM processor.)
As I'm typing this my keyboard's controller is an 8051 variant, the touchscreen of my phone also uses an 8051, the mouse has a 6502, and the monitors in front of me have an 80186 core in them.
They are fast enough for the task, cheap, and development tools widely available, so they really don't need to be replaced.