Electricity and bathrooms don't mix.
For added fun, estimate natural gas or electricity usage based on the type of water heater installed. Ok, so that would take this way past simple.
It is simply used as a failsafe.
There are vane based systems that will report actual flow rather than just whether flows or not.
Usually these work with a vane with a little magnet embedded, every revolution of the vane counts for so much water. They're not very accurate though (+- 20% or so, especially if the flow rates vary in a wide range).
A simple hall-effect sensor will act as the pickup on the outside of the copper or plastic housing that contains the vane assembly.
You can get calibrated ones too, these are used in places like gas stations. Those are pretty expensive though.
Also, rather than looking for sounds or temperature (which can easily produce a lot of false positives), you could simply make your tap into a switch and use it to trigger the clock.