Re:Ask HN: How do I get a hardware idea made? (by someone el...
by jacquesm on Tuesday November 10, 2009 @04:20PM
(#933965)
A flowswitch is a binary device, it is used in central heating systems to make sure the water is moving when the pump engages, if the pump has failed the flowsitch won't trip so the heater will display a 'friendly' error code instead of burning a bunch of gas for nothing, possibly damaging the burner.
It is simply used as a failsafe.
There are vane based systems that will report actual flow rather than just whether flows or not.
Usually these work with a vane with a little magnet embedded, every revolution of the vane counts for so much water. They're not very accurate though (+- 20% or so, especially if the flow rates vary in a wide range).
A simple hall-effect sensor will act as the pickup on the outside of the copper or plastic housing that contains the vane assembly.
You can get calibrated ones too, these are used in places like gas stations. Those are pretty expensive though.
It is simply used as a failsafe.
There are vane based systems that will report actual flow rather than just whether flows or not.
Usually these work with a vane with a little magnet embedded, every revolution of the vane counts for so much water. They're not very accurate though (+- 20% or so, especially if the flow rates vary in a wide range).
A simple hall-effect sensor will act as the pickup on the outside of the copper or plastic housing that contains the vane assembly.
You can get calibrated ones too, these are used in places like gas stations. Those are pretty expensive though.