News for hackers. Stuff that matters.
Re:A Xenon flash will cause the Raspberry Pi 2 to freeze by pjc50 on Saturday February 07, 2015 @08:10PM (#9016042)
All silicon is photosensitive to some extent. The power supply will be one of the few chips which is primarily "analog"; in particular it will have a bandgap voltage reference. That's exactly the sort of thing to be badly affected by a charge pulse from the flash. Glitching the power supply will then destabilise the digital logic it's powering.

The real question is how the light manages to get through the epoxy casing.

Re:A Xenon flash will cause the Raspberry Pi 2 to freeze by jarvist on Saturday February 07, 2015 @08:26PM (#9016084)
Epoxy resins are pretty transparent by themselves, opaque ones have additional materials or dyes added.

Most dyes (also aromatic organics) are not active (i.e. transparent) in the near-IR.

Re:A Xenon flash will cause the Raspberry Pi 2 to freeze by swamp40 on Saturday February 07, 2015 @11:31PM (#9016421)
Yes, but if you were tasked with designing the epoxy that was going to be used in every IC everywhere, I would hope that you would go through the extra effort of adding dyes that were specifically opaque to UV and IR.
Re:A Xenon flash will cause the Raspberry Pi 2 to freeze by swimfar on Sunday February 08, 2015 @01:28AM (#9016586)
Not exactly the same thing, but here's a really cool hack where it's possible to use a photosensitive dram chip as a digital camera.

https://www.cs.uaf.edu/2007/fall/cs441/support/dram_sensor_1...

Re:A Xenon flash will cause the Raspberry Pi 2 to freeze by rasz_pl on Sunday February 08, 2015 @12:17AM (#9016490)
there is no epoxy, smps controller is a flip chip bare die bga