News for hackers. Stuff that matters.
Re:A Xenon flash will cause the Raspberry Pi 2 to freeze by thought_alarm on Saturday February 07, 2015 @07:48PM (#9015977)
Why would a switched-mode-power-supply chip be photosensitive?
Re:A Xenon flash will cause the Raspberry Pi 2 to freeze by pjc50 on Saturday February 07, 2015 @08:10PM (#9016042)
All silicon is photosensitive to some extent. The power supply will be one of the few chips which is primarily "analog"; in particular it will have a bandgap voltage reference. That's exactly the sort of thing to be badly affected by a charge pulse from the flash. Glitching the power supply will then destabilise the digital logic it's powering.

The real question is how the light manages to get through the epoxy casing.

Re:A Xenon flash will cause the Raspberry Pi 2 to freeze by jarvist on Saturday February 07, 2015 @08:26PM (#9016084)
Epoxy resins are pretty transparent by themselves, opaque ones have additional materials or dyes added.

Most dyes (also aromatic organics) are not active (i.e. transparent) in the near-IR.

Re:A Xenon flash will cause the Raspberry Pi 2 to freeze by swamp40 on Saturday February 07, 2015 @11:31PM (#9016421)
Yes, but if you were tasked with designing the epoxy that was going to be used in every IC everywhere, I would hope that you would go through the extra effort of adding dyes that were specifically opaque to UV and IR.
Re:A Xenon flash will cause the Raspberry Pi 2 to freeze by swimfar on Sunday February 08, 2015 @01:28AM (#9016586)
Not exactly the same thing, but here's a really cool hack where it's possible to use a photosensitive dram chip as a digital camera.

https://www.cs.uaf.edu/2007/fall/cs441/support/dram_sensor_1...

Re:A Xenon flash will cause the Raspberry Pi 2 to freeze by rasz_pl on Sunday February 08, 2015 @12:17AM (#9016490)
there is no epoxy, smps controller is a flip chip bare die bga
Re:A Xenon flash will cause the Raspberry Pi 2 to freeze by lotsofmangos on Saturday February 07, 2015 @08:04PM (#9016027)
All chips are photosensitive and a xenon flash produces light from UV through to IR, so my guess would be that the plastic used for the casing on that chip is not entirely opaque to something at the top or bottom end of the visible spectrum, which is why most bright lights don't trigger it. At a bet, I'd say the top end, as otherwise radiant heaters would also probably kill them. Would be fun to play around with some filters and a flashgun and narrow down the frequency.
Re:A Xenon flash will cause the Raspberry Pi 2 to freeze by jarvist on Saturday February 07, 2015 @08:18PM (#9016065)
I think it's more likely to be the other way round, a lot of plastics are semi-transparent to IR, all block UV extremely strongly (as you start ionising electrons).

For instance, black PVC electrician's tape is entirely transparent to near-infrared, I use this to cover Xenon flashbulbs & still have an infrared-sensitive trigger fire from them.

Re:A Xenon flash will cause the Raspberry Pi 2 to freeze by lotsofmangos on Saturday February 07, 2015 @08:29PM (#9016086)
That was my first guess as well, the only reason I discounted it was that then I would expect the effect to happen more often. I could be entirely wrong there however.

edit - ars, I'm out of replies, but thanks for that. I think you are probably right.

Re:A Xenon flash will cause the Raspberry Pi 2 to freeze by ars on Saturday February 07, 2015 @08:55PM (#9016135)
It probably needs a short pulse. A normal light or a heater is constant and doesn't trigger anything. (AC vs DC.)
Re:A Xenon flash will cause the Raspberry Pi 2 to freeze by thrownaway2424 on Saturday February 07, 2015 @08:05PM (#9016031)
All semiconductor materials are photovoltaic to some extent.