News for hackers. Stuff that matters.
Re:Squink Lets You Print a Circuit Board for the Price of a ... by pkaye on Monday July 14, 2014 @11:43PM (#8034663)
Lots of issues will need to be worked out for this to be viable. 4 layers minimum (ground, power, 2 routing planes). High pitch TSOP and BGA need tight pitches and traces. The width of traces and spacing and dielectric material need tight tolerances for impedance control for signal integrity.

But they are not asking for much of an investment so it may be worthwhile to try it out.

Re:Squink Lets You Print a Circuit Board for the Price of a ... by cushychicken on Monday July 14, 2014 @11:57PM (#8034693)
That's assuming a level of complexity this doesn't appear to be shooting for. Sure, you probably couldn't build an RPi or BBB with this guy, but it seems that they're targeting a lower end shop trying to spin a few iterations of a low-cost IoT device before sending it out to a fab house. The level of complexity needed for that hardware isn't huge.
Re:Squink Lets You Print a Circuit Board for the Price of a ... by TylerE on Tuesday July 15, 2014 @12:03AM (#8034709)
I could also see e.g. the guys handbuilding guitar effects going nuts over something like this.
Re:Squink Lets You Print a Circuit Board for the Price of a ... by cushychicken on Tuesday July 15, 2014 @12:58AM (#8034868)
Yes! That would be great. So much more consistent than handsolder.