The Anderson Powerpole seems a rather effective and cheap way to shove a couple hundred watts of DC around. Of course there must be millions of existing connectors all operating at 12 volts so applying it to a 5V standard will be problematic at best. I have them all over my house given my electronic interests. Do NOT listen to people who complain about them, much like the legendary PL-259 connector or soldering SMD device by hand, 99.99% of the population just does it no problem without drama but the 0.01% who can't be bothered to learn how, make sure to very loudly tell everyone about how it never works, etc. Its tiresome but traditional.
The molex family seems most effective at demonstrating the flammability of overheated nylon, at least at power levels over a hundred or so watts.
The ancient Cinch plugs worked sorta well, although they're a bit large and fiddly.
Coaxial DC connectors are something of a standard although few can handle a hundred watts, at least at low DC voltage.
A miniaturized version of the standard used for intelligent electric vehicle charging would be interesting. There's probably a patent preventing innovation, but maybe in a few decades when existing patents run out thus permitting innovation to start again...
That's in itself is a lesson optimistic power connector designers need to learn about the past, if you "borrow" something currently used for marine power, or solar panel wiring, or forklift battery chargers, and try to do something totally different, expect some conflicts even if the new app dwarfs the old one by a couple orders of magnitude.
Yes, on a railroad locomotive engine I wouldn't randomly plug red/black ham radio powerpoles into the first railroad engine red/black that you see, its not going to be what you expected. Almost everywhere else, it will work.
I don't care about the 0.2mm USB logo relief. PAINT that stuff up. Contrasting colours, with the USB-logo side BRIGHT and SHINY, please.
http://media.idownloadblog.com/wp-content/uploads/2012/01/us...
I've explained this in more detail before:
http://www.reddit.com/r/askscience/comments/1oomt1/how_are_r...
You do realize USB ports can be vertical, and usually are on (USB-enabled) wall outlets, displays and desktop computers right?
And that's the simple case of vertical (flipped 90 on the long axis compared to most laptops) with USB-enabled extension cords lying on the floor, you plug straight down.
There is no consistency, your USB port may be on the left, right or back of your screen, what's the useful thing to standardize then? And it can jut out from a wall. And on a desktop tower, the USB port can be on the front or the back, and the user may install the machine so it is accessed from the left, the right or either.
Anyway the next discovery is I charge my phone face down to protect the glass, so I have to plug in upside down. Rightside up and Upside down connectors are commercially available for PCBs because the manufacturers have no idea which side might be up in a finished product. So you've converted the problem from figuring out which side of a cable is up, to memorizing which devices you own that have to be flipped upside down. Of course a dot of the same color paint fixes that although it might look ugly on a phone if done sloppily enough.
A greater annoyance is should the USB charger input be on the top, bottom, right or left side of all phones? I think I've seen it all.
See https://phandroid.s3.amazonaws.com/wp-content/uploads/2013/0...
What's needed is a robust connector with an easily visually determined orientation and the sort of power transmission capabilities that the new USB PD standard has.
Hopefully the manufacturers will have the sense to move towards a slightly more sane connector to use in everything. I think the fear that it has to be backwards compatible is less prevalent now than it used to be (micro USB has completely replaced mini USB in most situations). I'm looking forward to sane relatively high power DC connections everywhere.