Re:Bruce Schneier has changed his PGP key to 4096 bits
by maaku on Thursday September 12, 2013 @07:29PM
(#6377660)
Meh, you can do fine by using two one-way ethernet cables (you might have to cut the receive wires yourself), and some tweaked network stack.
[ Parent
| on HN ]
Re:Bruce Schneier has changed his PGP key to 4096 bits
by shabble on Thursday September 12, 2013 @09:16PM
(#6377997)
The ol' DIY Data-Diode[1]
I've heard of using serial lines/modems with the appropriate tx->rx cut, but I don't know if it would actually work for ethernet (maybe 10BaseT only?)
Re:Bruce Schneier has changed his PGP key to 4096 bits
by spin on Thursday September 12, 2013 @09:46PM
(#6378081)
I'm just speculating here... but I think it could be done PC-to-PC up to 100mbit. IIRC, there's a "link" signal that normally exists -- you'll have to configure both cards to ignore the link signal. (Which, I suppose, would mean that this wouldn't work going to a switch or hub with factory-default firmware.)
Half-duplex, 100mbit, ignore link. I suppose it can be done?....