News for hackers. Stuff that matters.
Re:Bruce Schneier has changed his PGP key to 4096 bits by pndmnm on Thursday September 12, 2013 @06:43PM (#6377489)
Years ago, a classmate of mine built a rig out of a receipt printer and one of those old handheld scanners to provide an "air gap", though it never really worked (sort of an art project at the time). Might be time to revive the idea...
Re:Bruce Schneier has changed his PGP key to 4096 bits by phunge on Thursday September 12, 2013 @11:18PM (#6378374)
How about 2 serial ports, connecting only TxD, RxD and GND? 3-wire RS-232 basically has no attack surface, there's no protocol to speak of. [edit: shabble already suggested this]
Re:Bruce Schneier has changed his PGP key to 4096 bits by reeses on Thursday September 12, 2013 @11:58PM (#6378508)
Something very similar to this has been used in the military to "bridge" network barriers at differing security levels. The US Navy uses "SDR" (Secure Data Replication) to transfer content under control.

You could get all stuxnet and exploit the various applications (such as the components that inspect zipped content), but the transport itself is a simple file copy over a bitstream. You could do the same thing with kermit and uuencode a bit more easily.

Re:Bruce Schneier has changed his PGP key to 4096 bits by maaku on Thursday September 12, 2013 @07:29PM (#6377660)
Meh, you can do fine by using two one-way ethernet cables (you might have to cut the receive wires yourself), and some tweaked network stack.
Re:Bruce Schneier has changed his PGP key to 4096 bits by shabble on Thursday September 12, 2013 @09:16PM (#6377997)
The ol' DIY Data-Diode[1]

I've heard of using serial lines/modems with the appropriate tx->rx cut, but I don't know if it would actually work for ethernet (maybe 10BaseT only?)

[1] https://en.wikipedia.org/wiki/Unidirectional_network

Re:Bruce Schneier has changed his PGP key to 4096 bits by spin on Thursday September 12, 2013 @09:46PM (#6378081)
I'm just speculating here... but I think it could be done PC-to-PC up to 100mbit. IIRC, there's a "link" signal that normally exists -- you'll have to configure both cards to ignore the link signal. (Which, I suppose, would mean that this wouldn't work going to a switch or hub with factory-default firmware.)

Half-duplex, 100mbit, ignore link. I suppose it can be done?....