In the first half of the 90s, pretty much every ISA graphics card had a 1024x768 @ 43i mode, and fancier ones could often do 1280x1024 at the same refresh rate (often accompanied by an ear-splitting whine coming from the monitor!)
This situation lasted until programmable PLLs that could do 72p began to take over in the mid 90s, swiftly followed by 90p. But by then the idea that anything above 800x600 was a recipe for eye-strain had been baked into the lore, and corporate IT departments in particular refused to risk going beyond it until well into the LCD era.
Sometimes, people didn't notice the issue and wondered why I was so motivated to fix a thing that they didn't perceive, but they noticed a positive improvement 100% of the time I spent a few minutes finding a good refresh rate and adjusting the geometry.
---
That said: Phosphor persistence varied, and therefore so did the the impact of refresh rates. So even though I was tuned into the thing, I never noticed any issues at all when working with a DEC VT330 terminal; the image was not flickery at all despite its 60Hz refresh rate. It accomplished this by using phosphors of relatively long persistence.
There was some ghosting evident on rapidly-scrolling text, but it worked well-enough for its normal intended uses.
Same with the Samsung CGA monitor I had back in the day. It's not like I could adjust its 60Hz refresh rate, but it was fine.
Things were far worse at 60Hz on the SVGA ViewSonic 5e that replaced the CGA kit. I spent a fair bit of time dialing out the 60Hz graphics modes in MS-DOS. (Text was always OK: VGA text mode is 70Hz.)
My parents have a plasma TV and I can clearly see it flicker, although it doesn't cause any pain.