News for hackers. Stuff that matters.
Re:The MacBook Pro's OLED PWM Problem: When a 'Better' Displ... by ssl-3 on Sunday November 15, 2026 @08:37PM (#50512984)
Back when desktop PCs were more common things to find in livingrooms, I improved so many lives by increasing the refresh rate of the monitor.

Sometimes, people didn't notice the issue and wondered why I was so motivated to fix a thing that they didn't perceive, but they noticed a positive improvement 100% of the time I spent a few minutes finding a good refresh rate and adjusting the geometry.

---

That said: Phosphor persistence varied, and therefore so did the the impact of refresh rates. So even though I was tuned into the thing, I never noticed any issues at all when working with a DEC VT330 terminal; the image was not flickery at all despite its 60Hz refresh rate. It accomplished this by using phosphors of relatively long persistence.

There was some ghosting evident on rapidly-scrolling text, but it worked well-enough for its normal intended uses.

Same with the Samsung CGA monitor I had back in the day. It's not like I could adjust its 60Hz refresh rate, but it was fine.

Things were far worse at 60Hz on the SVGA ViewSonic 5e that replaced the CGA kit. I spent a fair bit of time dialing out the 60Hz graphics modes in MS-DOS. (Text was always OK: VGA text mode is 70Hz.)

There are no comments on this comment yet.