News for hackers. Stuff that matters.
Re:The MacBook Pro's OLED PWM Problem: When a 'Better' Displ... by legitronics on Sunday November 15, 2026 @09:42AM (#50507268)
When I actually went to the source for the 240hz claim, I didn’t reach the same conclusion as the testers?

Maybe they just let their rigol scope spit out 240hz, but 480hz worst case and I would actually say 960hz. I think what’s happening with the tandem oled is they both pwm at 480hz and 180 degrees out of phase giving effective 960hz when both are in use. Which appears to be most of the usable brightness.

Re:The MacBook Pro's OLED PWM Problem: When a 'Better' Displ... by jrmg on Sunday November 15, 2026 @11:40AM (#50508308)
You’re right - looking at the scope pictures, the horizontal period of the grid is 2ms, and the period of the wave is just over that.

A 240Hz wave would have a period of 4.17ms. 480Hz is 2.08ms. Much closer to the oscilloscope waveforms. And even then the waveforms are periodic, with smaller troughs at every second dip.

I wish I could see their test setup. It would be ironic if the panel was fully DC dimmed and the troughs were from another light source or something…

I’m not sure why the scope is saying 240 though. It makes me doubt my understanding :-/.

[Edit: Ah - got it! It’s measuring the frequency of the very lowest points - the ‘every second dip’]

Re:The MacBook Pro's OLED PWM Problem: When a 'Better' Displ... by drfloyd51 on Sunday November 15, 2026 @12:29PM (#50508789)
Just adding a note to future readers: frequency is correctly measured dip to dip or top to top. Or every second time a particular value is reached.
Re:The MacBook Pro's OLED PWM Problem: When a 'Better' Displ... by jrmg on Sunday November 15, 2026 @12:59PM (#50509062)
The difficulty here is that it's 480Hz top-to-top, but there are two definitions of dip-to-dip depending on if you count every 'dip' from 100% (480Hz), or just the ones that reach the lowest voltage ⃰ (240Hz).

⃰ ⃰(brightness - presumably the test setup is an LDR or something?)

Re:The MacBook Pro's OLED PWM Problem: When a 'Better' Displ... by amluto on Sunday November 15, 2026 @01:14PM (#50509235)
Here's my hypothesis: I'm guessing that the reviewer's is using some kind of photodetector is sensitive, to different extents, to different portions of the scree. And that the actual display modulates at 240Hz but that some portions of the screen are 180 degrees out of phase with other portions. Or that one of the subpixel colors is out of phase with the others. This could explain the weird alternating-depth signal at ~2ms intervals.

Here's notebookcheck's review methodology:

https://www.notebookcheck.net/How-does-Notebookcheck-test-la...

And the sensor they use might be this one:

https://www.thorlabs.com/item/PDA100A2

That doesn't look like it's not even close to being able to focus on a single subpixel or even a single row without additional optics.

In any case, the 0% and 25% waveforms look pretty bad. In my experience, light with sharp, short pulses (like "driverless" LED lights produce) are unpleasant, but the unpleasantness is related to how bright the source is compared to everything else in the field of view. (The 0% and 25% waveforms are solidly at twice the frequency of driverless LEDs, which will make the effect considerably less bad.)

Re:The MacBook Pro's OLED PWM Problem: When a 'Better' Displ... by jrmg on Sunday November 15, 2026 @01:43PM (#50509478)
I like this hypothesis! It sounds very plausible.

Surely someone on HN has the equipment and curiosity to double-check all this as a Sunday afternoon project?…

Re:The MacBook Pro's OLED PWM Problem: When a 'Better' Displ... by amluto on Sunday November 15, 2026 @04:27PM (#50510977)
It would be entertaining to bring a serious high-speed camera with a macro lens to the Apple Store :)
Re:The MacBook Pro's OLED PWM Problem: When a 'Better' Displ... by aliher1911 on Sunday November 15, 2026 @04:57PM (#50511269)
Older samsung galaxy phones (till ~S21) had HW 960fps mode where it recorded 0.2s on sensor before switching back to normal fps. It is not macro, but maybe it could show the flicker rate of the whole screen or halves out of phase.
Re:The MacBook Pro's OLED PWM Problem: When a 'Better' Displ... by ky3 on Sunday November 15, 2026 @04:47PM (#50511171)
> Or every second time a particular value is reached.

The value is waving, so a complete cycle is when it got back to where it started: that is, not just its value but its _direction of change_ is also the same.

(A value waving in 3D could coincide with its start value multiple times before it completes a whole cycle.)

Re:The MacBook Pro's OLED PWM Problem: When a 'Better' Displ... by labcomputer on Sunday November 15, 2026 @11:03PM (#50513875)

  > [Edit: Ah - got it! It’s measuring the frequency of the very lowest points - the ‘every second dip’]
So that's the danger of [the authors] just reading the number off the screen without understanding what the scope is showing.

To measure frequency, typically the scope will measure the max and min of a waveform, then select a point halfway between them as the trigger point, then measure the time between successive triggers. Also, the trigger usually has an intentional hysteresis, so that noise near the midpoint does not cause multiple triggers on a slowly-rising waveform.

The little dips don't go down far enough below the midpoint to activate the hysteresis window, which is why it only counts every second dip.

Re:The MacBook Pro's OLED PWM Problem: When a 'Better' Displ... by rcxdude on Monday November 16, 2026 @05:28AM (#50516046)
In this case that's not necessarily incorrect, though. With the pulses alternating in amplitude by that much, there will be a component of the brightness variation which is at 240Hz and still visible (if the pulses were more closely matched, then it would be fainter). You don't need the trigger to measure this frequency in a single shot, either.

(The waveform looks more than a little odd, to me. Like they say, the DC value is changing as well, so the circuitry should be able to just output a flat value. The pulses don't really look like typical PWM, either. So I don't really know what exactly is going on there)

Re:The MacBook Pro's OLED PWM Problem: When a 'Better' Displ... by saltcured on Sunday November 15, 2026 @01:25PM (#50509323)
Their method is a photo detector driving the oscilloscope, right?

How can they assume the rise/fall slope in those plots is characterizing the driving electrical signal? Wouldn't a PWM driver be able to have much faster transitions and look more square than that at these time scales?

It makes me wonder if this is the response of the organic phosphors and the difference in apparent "depth" of the dip is really just a difference of duration, since the dips are very V-shaped, rather than bottoming out.

It is slightly odd that it has this paired rhythm, but I don't think you can assume it is "DC-dimming" rather than just PWM quanta that are being anti-alias filtered by the phosphors and measurement methodology.

Re:The MacBook Pro's OLED PWM Problem: When a 'Better' Displ... by Groxx on Sunday November 15, 2026 @02:19PM (#50509780)
[delayed]
Re:The MacBook Pro's OLED PWM Problem: When a 'Better' Displ... by saltcured on Sunday November 15, 2026 @02:58PM (#50510118)
The quoted text claims "dc-dimming" because some of the pulse "dips" do not reach the same detected photon level as the "off" screen state.
Re:The MacBook Pro's OLED PWM Problem: When a 'Better' Displ... by Klaus23 on Sunday November 15, 2026 @07:12PM (#50512374)
240 Hz looks correct to me. Of course it also has 480 Hz and other even higher components but the lowest significant component is 240 Hz. You can't disregard that half of the dips are much deeper. That will create a lower frequency flickering.
Re:The MacBook Pro's OLED PWM Problem: When a 'Better' Displ... by fsh on Monday November 16, 2026 @01:11AM (#50514569)
The authors are correct. The signal repeats every 4.2 ms, so the fundamental frequency is unambiguously 240 Hz. There is an even stronger second-harmonic component at 480 Hz, but this doesn't erase the 240 Hz flicker.
Re:The MacBook Pro's OLED PWM Problem: When a 'Better' Displ... by raxxorraxor on Monday November 16, 2026 @05:51AM (#50516184)
Hey, Rigol is dependable ;) - What do you mean in tandem? I thought oled doesn't use a backlight (I have little to no knowledge about displays). If it did, you would probably see a difference in amplitude depending on the diode you are using.

At least they probably measured with some form of photo diode instead of poking their osci into their mac trying to find the correct signal. This would measure the effective frequency for the eyes, no? So it would be 240Hz.