Re:The MacBook Pro's OLED PWM Problem: When a 'Better' Displ...
by rcxdude on Monday November 16, 2026 @05:28AM
(#50516046)
In this case that's not necessarily incorrect, though. With the pulses alternating in amplitude by that much, there will be a component of the brightness variation which is at 240Hz and still visible (if the pulses were more closely matched, then it would be fainter). You don't need the trigger to measure this frequency in a single shot, either.
(The waveform looks more than a little odd, to me. Like they say, the DC value is changing as well, so the circuitry should be able to just output a flat value. The pulses don't really look like typical PWM, either. So I don't really know what exactly is going on there)
To measure frequency, typically the scope will measure the max and min of a waveform, then select a point halfway between them as the trigger point, then measure the time between successive triggers. Also, the trigger usually has an intentional hysteresis, so that noise near the midpoint does not cause multiple triggers on a slowly-rising waveform.
The little dips don't go down far enough below the midpoint to activate the hysteresis window, which is why it only counts every second dip.