In case this wasn't obvious before, let me state this very clearly: Over 30% of the energy content of the natural gas used by your water heater goes up the chimney and is not used to heat the water. Gas water heaters and furnaces are NOT 100% efficient.
[1] Wikipedia claims that conventional external combustion (i.e., steam) power plants have a thermal efficiency of 33%.
[2] Wikipedia claims that transmission and distribution losses nationally averaged 6-7% in recent years.
Combination Boilers that provide both hot water for heating and hot tap water are advancing quickly. Flexible PEX tubing these cut out a ton of traditional cutting and brazing plumbing labor to install hot water loops. It's also a lot more efficient to move hot water to a heat exchanger of some form in each room than to push air through ductwork. Some of these rigs also can be easily combined with a solar thermal roof array, further cutting your gas or electric costs.
I'm pretty excited about the last option, since I have an older house with poor air return paths, which means my furnace is almost always ingesting chilly basement air rather than getting a nice recirculation of heating air that's already been heated. Not to mention radient heat exchangers are silent and allow easy individual room temperature control with the smarter thermostat systems.
If I turn the heat on in all the rooms, I can watch the electric meter spin.
Not this is a _reflective_ layer, not just insulation. The thermodynamics of radiant heat systems involve photon transmission, not just gas convection. If it was installed by a general contractor they may not have understood this distinction and the need for aluminum couplers and metalized reflective insulation.
>Not to mention that gas heaters are simply more efficient for heating to begin with.
Are you sure about that? A heat pump with a COP of, say, 2 is 300% efficient (it is said to have an Energy Factor, EF, of 3). That is, for every Joule of electrical energy supplied to the pump, 3 Joules are added to the water tank. On the other hand, the combustion products of a natural gas heater need to be exhausted outside the building. Unless they are first cooled to the temperature outside, the heater is less than 100% efficient.
Where I live, a Joule from the electric company costs about 2.5 to 3 times as much as a Joule from the gas company. A quick Google search indicates that this type of water heater typically has an EF of 2 to 2.5. The cheapest gas heater I could find on the Home Depot website was over $300 (twice your Mexican one) with an EF of 0.62. So it wouldn't surprise me if the energy cost of an electric is on par with the energy cost of a gas heater, and it would surprise me if the electric actually used more energy. I don't see how you would save thousands of dollars in energy with a gas heater: Even in the worst case (a 2 EF electric heat pump vs. a 0.62 EF gas in a location with a 3x energy cost ratio), the gas only just breaks even.