Re:Antigravity 2.0 Tops the OpenSCAD Architectural 3D LLM Be...
by pelagicAustral on Friday May 22, 2026 @07:15AM
(#48234317)
I just use Claude Code and intellij, so I don't understand why so many people complain about Antigravity ditching VS Code, what's the surface not covered by using Antigravity CLI + VS Code (or any other IDE)?
[ Parent
| on HN ]
Re:Antigravity 2.0 Tops the OpenSCAD Architectural 3D LLM Be...
by freedomben on Friday May 22, 2026 @07:18AM
(#48234340)
I'm not GP, but I am somewhat excited about antigravity CLI. I adopted Gemini CLI early and really liked it, though over time it got dumber and dumber until a point when I realized it was foolish to use it instead of claude/codex. I'm hopefuly that antigravity CLI won't go through that path, but also can't fight a skepticism.
Re:Antigravity 2.0 Tops the OpenSCAD Architectural 3D LLM Be...
by jeromegv on Friday May 22, 2026 @08:41AM
(#48235067)
I don’t think it’s the cli that was dumber, just the model it was using. They drastically reduced limits on their best model so that’s likely how you got stuck downgrading model and getting worse results.
Re:Antigravity 2.0 Tops the OpenSCAD Architectural 3D LLM Be...
by WarmWash on Friday May 22, 2026 @09:59AM
(#48235954)
I'm sensing in reality that behind the scenes there is a difficult trade-off between quantization and usage limits. You can have a "smart" model but poor limits, or good limits and a "dumb" model.
This seems very similar to mobile data limits (remember those years?), where there wasn't enough tower bandwidth to serve everyone unlimited data, so telecos were in constant tension between data caps and bandwidth throttling.
It wasn't until 5G came along with 100x network capacity that they could finally give everyone "unlimited" data.
Re:Antigravity 2.0 Tops the OpenSCAD Architectural 3D LLM Be...
by antonvs on Friday May 22, 2026 @10:07PM
(#48243847)
Which plan were you on? Gemini CLI auto-downgrades the model if you run out of tokens on the better models. It gives you stats about the models used at the end of every session.
Re:Antigravity 2.0 Tops the OpenSCAD Architectural 3D LLM Be...
by jeromegv on Friday May 22, 2026 @08:40AM
(#48235060)
Gemini cli was open source. Antigravity cli is not. Not at feature parity, missing many features and now we are forced to migrate away from Gemini cli before anti gravity cli is ready.
Re:Antigravity 2.0 Tops the OpenSCAD Architectural 3D LLM Be...
by surajrmal on Friday May 22, 2026 @09:06AM
(#48235350)
The difference in its ability is immense. Even with less features it makes a lot of sense to switch. It really shows how much the harness matters almost equally to the model.
Re:Antigravity 2.0 Tops the OpenSCAD Architectural 3D LLM Be...
by lern_too_spel on Friday May 22, 2026 @12:57PM
(#48238463)
At least one of the missing features is a basic piece of functionality (showing token quota used). Without it, you're pretty much guaranteed to get locked out for a week with no warning.