Re:New Patches Allow Building Linux IPv6-Only, Option to Dep...
by UltraSane on Wednesday April 01, 2026 @12:35PM
(#47603165)
You can have IPv6 firewalls emulate the behavior of NAT so it blocks unsolicited inbound traffic while allowing outbound traffic. If you get a /48 form your ISP you could rotate to a new IP address every second for the rest of your life.
[ Parent
| on HN ]
Re:New Patches Allow Building Linux IPv6-Only, Option to Dep...
by iamnothere on Wednesday April 01, 2026 @12:38PM
(#47603201)
Right, but if you’re messing around as a naive learner it’s easy to accidentally disable that or completely open up an IP or range due to a bad rule. It’s a lot harder to accidentally enable port forwarding on a NAT.
Re:New Patches Allow Building Linux IPv6-Only, Option to Dep...
by degamad on Wednesday April 01, 2026 @01:16PM
(#47603727)
> It’s a lot harder to accidentally enable port forwarding on a NAT.
It's probably less than three clicks on most home router web UIs.
Re:New Patches Allow Building Linux IPv6-Only, Option to Dep...
by MisterTea on Wednesday April 01, 2026 @02:00PM
(#47604288)
But you have to specify not only the exposed port but also the destination address and port which is not easy to do accidentally.
edit: typo
Re:New Patches Allow Building Linux IPv6-Only, Option to Dep...
by iamnothere on Wednesday April 01, 2026 @01:43PM
(#47604079)
Very hard to make all those clicks accidentally. But anyway I’m talking about pf/iptables rules, not web UIs.
Re:New Patches Allow Building Linux IPv6-Only, Option to Dep...
by throw0101c on Wednesday April 01, 2026 @05:51PM
(#47606986)
> You can have IPv6 firewalls emulate the behavior of NAT so it blocks unsolicited inbound traffic while allowing outbound traffic.
Are there any (consumer?) firewalls that do not do this? I know Asus do this (and have for years).
AIUI most 'enterprise' firewalls have a default deny shipped from the factory and you have to actively allow stuff.