Re:Indian Startup 3D Prints Rocket Engine in Just 72 Hours
by gridspy on Thursday June 13, 2024 @03:21PM
(#40673495)
I'm sure even in this case, risking the air-frame of the bomber or friendlies on the ground below is not ideal. Bear in mind cruise missiles are usually launched from friendly territory.
Also, failures might reduce the accuracy of the missile, leading to potential civilian causalities.
Re:Indian Startup 3D Prints Rocket Engine in Just 72 Hours
by sandworm101 on Thursday June 13, 2024 @03:22PM
(#40673510)
>> cruise missile dropped at altitude where a failure isn't a big deal.
If failure isn't a big deal, then the weapon should no have been used. An ALCM costs millions. The destruction it causes is part of a larger battle plan. Should it not work properly then friendly forces may die. Should it work properly then enemy forces may die. The effectiveness of such a weapon is never not a big deal.
Re:Indian Startup 3D Prints Rocket Engine in Just 72 Hours
by DrFalkyn on Friday June 14, 2024 @12:50AM
(#40677570)
If it’s that critical then they aren’t launching one cruise missile.
If system A costs 1k quid but only works 50% of the time, while system B works 99% of the time but costs 10k quid, system A actually makes a lot more sense. On average you are going to spend a lot less money for the same outcome.
Unless this was something like a cruise missile dropped at altitude where a failure isn't a big deal.