News for hackers. Stuff that matters.
Re:Why do electronic components have such odd values? (2021) by afiori on Tuesday June 04, 2024 @02:29PM (#40577509)
I wonder about the effect of different wiring patterns. For example you can can combine N^2 resistors in N parallel strips of N resistors in serie.

I expect that in this case the uncertainty would decrease

Re:Why do electronic components have such odd values? (2021) by RetroTechie on Tuesday June 04, 2024 @02:50PM (#40577719)
In the article's example, I'd prefer 2 resistors in parallel. That way result is less dramatic if 1 resistor were to be knocked off the board / fail.

Eg. 1 resistor slightly above desired value, and a much higher value in parallel to fine-tune the combination. Or ~210% and ~190% of desired value in parallel.

That said: it's been a long time since I used a 10% tolerance resistor. Or where a 1% tolerance part didn't suffice. And 1% tolerance SMT resistors cost almost nothing these days.

Re:Why do electronic components have such odd values? (2021) by bombela on Wednesday June 05, 2024 @03:11AM (#40582195)
This might be why pretty much all LED lightbulbs/fixtures have two resistors in parallel. Used for the driver chip control pin, that sets the current to deliver via some specific resistance value.

It's always a small and a large resistor. The higher this control resistance, and the lower the driving current.

Cut off the high value resistor to increase the resistance a bit. In my experience this often almost halves the driving current, and up to 30% of the light output (yes, I measured).

Not only most modern lights are too brights to start with anyways, this fixes the intentional overdriving of the LEDs for planned obsolescence. The light will last pretty much forever now.

Re:Why do electronic components have such odd values? (2021) by afiori on Tuesday June 04, 2024 @02:46PM (#40577679)
Iterating either of

f(x) = 3/(1/x + 1/110 + 1/90)

g(x) = 1/(1/(3x) + 1/(3110) + 1/(3*90))

Seems to show that 100 is a stable attractor.

So I will postulate without much evidence that if you link N^2 resistors with average resistance h in a way that would theoretically give you a resistor with resistance h you get an error that is O(1/N)