I expect that in this case the uncertainty would decrease
Eg. 1 resistor slightly above desired value, and a much higher value in parallel to fine-tune the combination. Or ~210% and ~190% of desired value in parallel.
That said: it's been a long time since I used a 10% tolerance resistor. Or where a 1% tolerance part didn't suffice. And 1% tolerance SMT resistors cost almost nothing these days.
It's always a small and a large resistor. The higher this control resistance, and the lower the driving current.
Cut off the high value resistor to increase the resistance a bit. In my experience this often almost halves the driving current, and up to 30% of the light output (yes, I measured).
Not only most modern lights are too brights to start with anyways, this fixes the intentional overdriving of the LEDs for planned obsolescence. The light will last pretty much forever now.
f(x) = 3/(1/x + 1/110 + 1/90)
g(x) = 1/(1/(3x) + 1/(3110) + 1/(3*90))
Seems to show that 100 is a stable attractor.
So I will postulate without much evidence that if you link N^2 resistors with average resistance h in a way that would theoretically give you a resistor with resistance h you get an error that is O(1/N)
In reality, some manufacturers may measure some components, and the ones within 1% get labeled as 1%, then it may be that when you're buying 5% components that all of them are at least 1% off, and the math goes out the window since it isn't a normal distribution.