For what it's worth, I have also replaced my own garage door spring, and I really have no desire to do that again.
It also provides a constant force, whereas the force required to raise a garage door linearly decreases the higher it gets. With the consequence that a garage door with a failed motor would slam into its stops over your head rather then into the ground. Followed shortly thereafter by the now liberated counterweight slamming into the ground.
https://www.physics.smu.edu/scalise/www/misc/bricks.html
*Wrong link
Springs make a lot of sense from an installation perspective and can be easily tuned to match the specific door design, but if I was working from scratch on a DIY project I would definitely use a counterweight.
You'd have to match the counterweight to the varying load (i.e. garage door effectively gets "lighter" the more its raised).
Of course, there may be some cost issues with this solution...
garage door springs are safe if you are careful and you use the correct tools and procedures. the instant you take a shortcut with these, you increase the likelihood of a bad outcome.
so, don't take shortcuts, and don't do the work if you don't know what you're doing.
the professionals know this and that's why we pay them, but they're not special creatures with special abilities; they're people who understand that this is a situation which can bite you, and they act accordingly.
Just about anyone can change their garage door springs, if they do so correctly.
Garage doors are actually fairly heavy. By balancing the weight with a spring, you do a lot of favors to your mechanical advantage systems. (Eg: less wear, less advantage needed, the door can open in a reasonable amount of time…) You also do yourself a few favors for when things fail. (Eg: you pull the safety release and it’s possible to open the door without the motor.) Finally, power isn’t free and motors aren’t either; A spring is a really cheap way to reduce the cost of both of these things.