News for hackers. Stuff that matters.
Re:How I Replaced Deadly Garage Door Torsion Springs by MadnessASAP on Monday March 18, 2024 @11:01PM (#39752530)
A few hundred points accelerating at 1g is still plenty of energy. It also comes with it's own challenges when it comes to releasing it.

It also provides a constant force, whereas the force required to raise a garage door linearly decreases the higher it gets. With the consequence that a garage door with a failed motor would slam into its stops over your head rather then into the ground. Followed shortly thereafter by the now liberated counterweight slamming into the ground.

https://www.physics.smu.edu/scalise/www/misc/bricks.html

*Wrong link

Re:How I Replaced Deadly Garage Door Torsion Springs by Retric on Tuesday March 19, 2024 @06:19AM (#39754331)
Counterweights don’t need to take a straight path to the ground. The force a weight pulls on a surface is based on the tangent.
Re:How I Replaced Deadly Garage Door Torsion Springs by matt-attack on Tuesday March 19, 2024 @10:00AM (#39755804)
True but by adjusting the angle you still end up with a fixed weight throughout the run. A spring force changes throughout the movement of the garage door and that’s chosen to match the unusual fact that the garage door’s weight changes as it’s gets progressively rolled up onto the top rails.
Re:How I Replaced Deadly Garage Door Torsion Springs by Retric on Tuesday March 19, 2024 @11:33AM (#39756830)
A fixed weight but not angle means the force varies. Cut the cable and acceleration would therefore also vary with that angle along the track.

Springs make a lot of sense from an installation perspective and can be easily tuned to match the specific door design, but if I was working from scratch on a DIY project I would definitely use a counterweight.