News for hackers. Stuff that matters.
Re:USB-C power for your Amiga 500, 600 and 1200 by rob74 on Friday February 02, 2024 @03:13AM (#39226349)
I imagine the physical switch and the grilles are a tribute to the original power supplies (A500: https://i.ebayimg.com/images/g/wbYAAOSwW1JlX0FB/s-l1600.jpg). The site doesn't give any hint about the color, but I would bet it will be beige...

That being said, the claim that it works with "any 12V-capable USB-C power supply" sounds very ambitious. Is any 12-V capable USB-C power supply capable of delivering 60+ watts?

Re:USB-C power for your Amiga 500, 600 and 1200 by unwind on Friday February 02, 2024 @03:44AM (#39226541)
The sustained power levels are listed as:

      5V: 4.5A
     12V: 1.0A
    -12V: 0.1A
I get 44.5+121+12*0.1=35.7 W from that, but then there has to be some losses too in that 5 V-regulation, but 60 W is probably a bit extreme. No idea how much power an Amiga consumes, though ... found [1] which states 35.7 W (hm) or 25.7 W so it seems to be aiming for the higher of the two which of course makes sense. The A600 and A1200 need even less, max 22.2 W for both models.

[1]: http://www.ianstedman.co.uk/amiga-power-supply-guide/

Re:USB-C power for your Amiga 500, 600 and 1200 by rob74 on Friday February 02, 2024 @03:50AM (#39226577)
I did more or less the same calculation when I arrived at 60 W, but with the peak power levels - if a PSU isn't able to deliver the peak current, which is probably needed when the computer boots up (with the HD spinning up etc.), I'm afraid it won't get to the "sustained" phase...
Re:USB-C power for your Amiga 500, 600 and 1200 by danby on Friday February 02, 2024 @04:42AM (#39226886)
Most amigas users are using some kind of solid state storage these days which will ameliorate this a little. But many/most are using assorted expansion and accelerator cards which can substantially increase the power draw.

It's a bit if a moveable feast how much power an amiga is drawing these days. Certainly, back in the 90s, the original a1200 power supplies often needed to be replaced with something that could deliver more, and the a500 supplies were favoured

Re:USB-C power for your Amiga 500, 600 and 1200 by bluescrn on Friday February 02, 2024 @05:00AM (#39226989)
Many Amigas also have a Raspberry Pi inside them these days, for the PiStorm accelerator, which increases the +5V current requirements a fair bit.
Re:USB-C power for your Amiga 500, 600 and 1200 by danby on Friday February 02, 2024 @05:48AM (#39227250)
Is the pi usually on it's own power supply?
Re:USB-C power for your Amiga 500, 600 and 1200 by bluescrn on Friday February 02, 2024 @11:11AM (#39230288)
Not with the PiStorm32 Lite that I've got.

Seemed to run OK with a Pi 4 on an original Commodore PSU, or at least nothing appears to have blown up or melted when running it for short periods.

Maybe I'm pushing my luck, but then again, back in the day, you'd often be running an accelerator board, hard drive, and a couple of floppy drives from that same PSU, so maybe it's up to the job.

Re:USB-C power for your Amiga 500, 600 and 1200 by gbraad on Friday February 02, 2024 @03:44AM (#39226536)
No, mostly limited to [email protected] (30W) or max @3A as that is the max amperage for a cable without an e-marker.

Confused by:

> allows users to tap into a vast array of affordable and readily available “power bricks”

followed by

> Furthermore, portable USB-C “chargers” are also supported,

So I expect it means it has a USB-C plug and you can feed 12V directly like with the Miniware / Pinecil soldering irons. Though, is this protected for overvoltage?

> If an over- or under-voltage

So, most likely you can only feed 12V. A Dell-brick , like the DA-2 would work: 12V@18A = 216W... but the plug itself has a max 12V@1A :-/. So a cheap 12V@5A brick might be enough for the total wattage (including the 5V rail).