News for hackers. Stuff that matters.
Re:CNC Lasers for Cutting and Engraving by looofooo0 on Saturday January 27, 2024 @04:17AM (#39153974)
Fun fact: in Uni people doing stuff with not so strong white laser are using VR headsets with see through mode
Re:CNC Lasers for Cutting and Engraving by cenamus on Saturday January 27, 2024 @04:50AM (#39154134)
Sounds like quite a good solution actually, low latency and all. Do you know if they fitted any filter over the headset cams to protect those just in case?
Re:CNC Lasers for Cutting and Engraving by avar on Saturday January 27, 2024 @06:33AM (#39154700)
Why would they need a filter? The laser light isn't making it directly to the eyeballs of the wearer.

The worst you'll get is 100% illumination on all pixels on the LCD inside the headset.

You can't stare at the Sun, but you can stare at a video of the Sun.

Re:CNC Lasers for Cutting and Engraving by maxerickson on Saturday January 27, 2024 @06:39AM (#39154740)
The question is clearly about protecting the camera from the laser.
Re:CNC Lasers for Cutting and Engraving by looofooo0 on Saturday January 27, 2024 @08:17AM (#39155293)
Well white laser cannot be blocked with normal Kameras.
Re:CNC Lasers for Cutting and Engraving by taskforcegemini on Sunday January 28, 2024 @04:59AM (#39164102)
camera sensors are pretty easy to damage. a lot of people destroy their cameras by filming solar eclipses without taking any precaution
Re:CNC Lasers for Cutting and Engraving by jacquesm on Sunday January 28, 2024 @06:11AM (#39164518)
Yes, definitely. You will want to protect your camera sensor from a direct hit by a laser (or even an indirect one). Diffused is probably ok.
Re:CNC Lasers for Cutting and Engraving by zokier on Saturday January 27, 2024 @09:19AM (#39155732)
White laser? Rgb or something else
Re:CNC Lasers for Cutting and Engraving by looofooo0 on Wednesday January 31, 2024 @12:27PM (#39206597)
No, normal Laser which goes through a non linear optimal element. See supercontinuum