My 2021 Mazda uses a timing chain. My 2004 BMW uses a timing chain. My old 1990 BMW had a chain. My folks' 2019 Lexus and 2016 Toyota both use chains.
Honda was a notorious holdout that still mostly used belts for a long time, but even they are coming around and some new models use chains now.
Mostly yes they are, which is wonderful compared to timing belts. It rubs my engineer brain intensely wrong to have such a critical engine component be designed as a wear item, especially when its failure can cause engine rebuild levels of damage.
However not all manufacturers' quality lives up to the intended design. VW/Audi have a spotty record with various well-known timing chain problems ranging from bad chain tensioners that fail and cause the chain to jump timing to plastic chain guides that break and wreak general havoc.
But for most cars a timing chain will last the life of the engine.
But it wasn't just a matter of the chain. All Saturns burned oil from the git-go, and as a bonus, a low oil level would cause the timing chain to lose lubrication, thus causing it to wear out. People who religiously topped off their oil, every time they re-fueled, kept their Saturns for a long time. I was not one of those people.
My next car was a Toyota, which I still drive. The Toyota engine is designed to make it easy to service the timing belt at the prescribed interval, and the car consumes no oil.
I'm definitely more careful with my newer cars.
My first car didn't burn oil, but dripped. I'd just top off the oil whenever I started hearing the tappets clicking. It was quite a forgiving engine, a 1975 Dodge.
The main reason why MB lasts so long is due to a single component in the engine,
they still use a chain rather than a timing belt. This one little change has so
much impact on the rest of the engine design that they tend to last very long
compared to cars that have timing belts.
No.Timing chain vs gear vs belt has little-to-no bearing on the longevity of an engine. You can, for instance, build an engine with a timing chain that's prone prone to catastrophic failure of the timing components. Mercedes has done it twice so far with the M116 and the M272/M273.
Suddenly a whole pile of stuff is happening inside the engine enclosure
instead of outside of it reducing the number of seals and in general reducing
complexity outside of the engine core. It also reduces the need for complex
service.
Tell that to anyone who's had a Ford with the Duratec or EcoBoost and an internal water pump.Meanwhile people put hundreds of thousands of miles on Volvo's old four cylinder with a… timing belt which takes all of thirty minutes to replace.
Chains vs gears vs belts has no bearing on longevity. The big difference is that chains are smaller and when you need to work on a chain it's generally far, far more complex than a belt drive. Don't forget that engines like the Ecotec, EcoBoost, M272, N20, and 2.0T are basically the bread and butter of those companies. They are high volume mass market engines.
Mercedes tend to last a long time because they're expensive, people pay to repair and maintain them, and nearly any Mercedes part for any Mercedes car can still be purchased new.
As for repair and maintenance: that's a nice bit of circular reasoning, the reason those parts can still be bought new is because there is still demand for them: the cars are still running.
When you start looking for cars that are 15 years and older (which is my bracket in NL) there really are only two brands that stand out: Volvo and MB. The rest are lucky accidents and this is reflected in the state of the rest of the cars as well. But as a rule car engines will fail well before the body does and with MB (and Volvo) it tends to be the other way around.
It's a bit old fashioned, timing belts result in an engine that runs a little bit more quiet and they make for a lighter package. So it's easy to see why many manufacturers would choose that option. But MB got that bit right (they also got plenty wrong, their software for instance absolutely sucks).