News for hackers. Stuff that matters.
Re:The giant die casts reshaping car manufacturing by elif on Wednesday February 15, 2023 @12:58PM (#34807857)
If you bend a frame rail in a composite structure, you have x new welds you have to perform, y rivets, z bolts, w plastic pins and spacers.

Some of those attachments were not designed to be removed and performed again, so you're looking at removing and replacing otherwise okay parts and then probably realizing that some other piece is slightly out of alignment and can't safely be reused...

If you bend a a unibody casting, firstly there is a larger chance that it is non-critical since there is so much added mass and structure. It is not a series of dominos like in a composite.

Secondly, all the attachment points are cast into the part. Replacement of one large piece is a significant reduction in effort, and results in more confidence in the ultimate repair.

Re:The giant die casts reshaping car manufacturing by winrid on Wednesday February 15, 2023 @01:03PM (#34807937)
That "one large peice" is literally the entire unibody. You going to re-shell a street car like a racecar?
Re:The giant die casts reshaping car manufacturing by dsfyu404ed on Wednesday February 15, 2023 @02:26PM (#34809241)
>Some of those attachments were not designed to be removed and performed again

Just because the OEM didn't bother to figure it out doesn't mean nobody can. There's all sorts of trick specialty repair parts and procedures in the aftermarket autobody industry to fill the gaps the OEM couldn't be bothered to.