Re:230 years since British pirates robbed the US of the metr...
by defrost on Monday January 23, 2023 @06:17PM
(#34496501)
Carpenters, woodworkers, metalworkers, electricians, etc. who work at a 10 to 50 foot (for the central north americans that like that kind of retrograde unit) scale AND who want a good fit ...
Millimeter fit on cabinets is the fit you want, whether you work in metric, British Imperial, or US Common.
When you have a long kitchen counter you're looking at 3 metres or more ( ~10 ft ) with framing and doors that join with barely the width a fingernail between.
The measurements are 10 foot (two digits), 6 inches, (another digit) and then a bit (tenths or hundredths of an inch, or a fraction - depending which you prefer).
That's ~ 4 digits for each measurement on a common household task.
It's pretty simple doing this as 3245mm on paper .. tradies have been doing this here since the 1970s and nothing's fallen down yet.
Dunno about you, I'm primarily a mathematican doing applied work - but I've worked as a TA (trades assistent) in electrical, gas fitting, plumbing, heavy mechanical, rigging (multi sling heavy lifting), welding, etc. (too much exposure to minesites and cattle stations I guess) and there's an entire class of people that are comfortable working with measurements that span the length of a truck and are accurate to the millimetre (or tenth of an inch) - so, four digits? No worries.
Millimeter fit on cabinets is the fit you want, whether you work in metric, British Imperial, or US Common.
When you have a long kitchen counter you're looking at 3 metres or more ( ~10 ft ) with framing and doors that join with barely the width a fingernail between.
The measurements are 10 foot (two digits), 6 inches, (another digit) and then a bit (tenths or hundredths of an inch, or a fraction - depending which you prefer).
That's ~ 4 digits for each measurement on a common household task.
It's pretty simple doing this as 3245mm on paper .. tradies have been doing this here since the 1970s and nothing's fallen down yet.
Dunno about you, I'm primarily a mathematican doing applied work - but I've worked as a TA (trades assistent) in electrical, gas fitting, plumbing, heavy mechanical, rigging (multi sling heavy lifting), welding, etc. (too much exposure to minesites and cattle stations I guess) and there's an entire class of people that are comfortable working with measurements that span the length of a truck and are accurate to the millimetre (or tenth of an inch) - so, four digits? No worries.
Why do you struggle with that?