News for hackers. Stuff that matters.
Re:1.461 seconds from 0 to 100km/h: students break accelerat... by titzer on Wednesday October 12, 2022 @03:23PM (#33181753)
Uh no, do not put 50,000 volts through 12 AWG wire.
Re:1.461 seconds from 0 to 100km/h: students break accelerat... by cesaref on Wednesday October 12, 2022 @03:29PM (#33181867)
As has been stated, voltage isn't a limitation, its the current that. Go and look at the HT wiring used in a cathode ray tube display, and you'll see it's a lot less that 12 AWG, and happily carries 10-20kV.
Re:1.461 seconds from 0 to 100km/h: students break accelerat... by the_third_wave on Wednesday October 12, 2022 @03:39PM (#33181978)
When I went to high school the teacher told about a science fair where someone had put a sign next to his project reading:

   WARNING
   2 million Ohms
(or something like that, I don't remember the actual number of Ohms for this specific project)

A remarkable number of people kept their distance from this obviously dangerous experiment.

The chemistry-equivalent of this joke is to warn everyone around you of the presence of dangerous di-Hydrogen Oxide which kills hundreds of thousands of people every year.

Re:1.461 seconds from 0 to 100km/h: students break accelerat... by rascul on Wednesday October 12, 2022 @03:48PM (#33182075)
> The chemistry-equivalent of this joke is to warn everyone around you of the presence of dangerous di-Hydrogen Oxide which kills hundreds of thousands of people every year.

https://dhmo.org/facts.html

Re:1.461 seconds from 0 to 100km/h: students break accelerat... by comboy on Wednesday October 12, 2022 @03:52PM (#33182122)
In their defense, maybe those people didn't know if it's a project by a very clever student or by the one who mixes up units ;)
Re:1.461 seconds from 0 to 100km/h: students break accelerat... by elliottkember on Wednesday October 12, 2022 @06:11PM (#33184288)
2 million ohms? Not bad, not terrible. Vasily, get the good Ohmmeter from the safe.
Re:1.461 seconds from 0 to 100km/h: students break accelerat... by jefftk on Wednesday October 12, 2022 @03:27PM (#33181829)
What goes wrong?
Re:1.461 seconds from 0 to 100km/h: students break accelerat... by WJW on Wednesday October 12, 2022 @03:42PM (#33181998)
Most store-bought wires won't have sufficient covering to prevent arcing, so you might get a short circuit somewhere. If you insulate the wires sufficiently however, any wire will take almost any voltage. It's the current you should worry about, as other commenters have already mentioned.
Re:1.461 seconds from 0 to 100km/h: students break accelerat... by quickthrowman on Wednesday October 12, 2022 @03:48PM (#33182061)
Why not? You obviously wouldn’t do it to a THHN conductor that is rated for 600v, but there are certainly #12 AWG conductors rated for higher voltages. They have a whole lot more insulation/layers than a regular 600v rated conductor, see: https://www.powerandcables.com/wp-content/uploads/2019/10/Fi...

High voltage utility distribution lines aren’t insulated by anything other than porcelain bushings and air.

Re:1.461 seconds from 0 to 100km/h: students break accelerat... by gooseyman on Wednesday October 12, 2022 @04:08PM (#33182357)
Came here to say this. Romex/THHN might be a bad idea, but that's because they weren't insulated for this purpose. 12 AWG would work.
Re:1.461 seconds from 0 to 100km/h: students break accelerat... by josephcsible on Wednesday October 12, 2022 @03:52PM (#33182131)
The term "12 AWG" only specifies conductor thickness. Voltage is limited by insulation and current is limited by conductor thickness. Assuming sufficient insulation, it's safe to run arbitrarily high voltages through any conductor, since it doesn't even "see" the voltage.