Luckily we just added hyper heat air source heat pumps to the rest of the house. We also have hydronic heat from an oil-fired boiler, which we are planning to only use when it’s too cold for the heat pumps (less than 25 degrees F).
The boiler also supplies hot water, so looking to replace that with a heat pump water heater to avoid burning oil in the summer. However, even with the efficiency of heat pumps, the electricity is mostly generated with gas, which is <40% efficient (factoring in transmission and distribution losses). Our boiler is 82% efficient, so from a carbon/GHG point of view, heat pump water heater may not be any better. Of course electricity is fungible, so more nuclear, solar, and wind would change the equation.
What I want to know is, where is the Department of Energy, etc. guidance on this. I have a fair amount of experience with energy policy and technology and the right path is far from clear to me.
[1] https://www.familiesforcleanair.org/catalytic-wood-stoves-sh...
I'm not sure what to make of the Finnish study. Full version is here: https://sci-hub.se/10.1016/j.chemosphere.2012.02.027. It's hard to know how the elevated levels compare to other sources, since 2x of almost zero might still be negligible. It does mention though that the "PCDD/F level exceeded the emission limit in Europe for MSW incinerators" so maybe it's real.
One other factor that might help us remain "smug" about our modern wood stoves is that the Finnish study was done on sauna stoves without secondary combustion and with high flue gas temps. I suspect the results might be completely different for compliant woodstove with good secondary and much lower flue temps. Of course, different might end up worse.
People also don’t understand you can’t regulate the output of fireplaces short-term. „Oh it’s getting hot in here, I’m gonna close the air supply” - and boom you’ve turned subpar unclean combustion into oxygen-starved combustion. Good job! But wood is CO2 neutral /s
It’s trivial to plug the fireplace when it’s not being used, to mitigate heat loss.
Catalytic converters basically do that with CO
FYI the article is talking about industrial power wood burning, not personal consumption.
They're mandated by law in many places now.
Anecdotally, friends in the Yukon used to burn ~10 cords of wood a winter. After upgrading to a catalytic combusting wood stove they now burn about 5 cords. Same house, same wood.
Thank you, I just learned a new word/unit of measure (cord) and went down the rabbit hole:
https://en.wikipedia.org/wiki/Cord_(unit)
has a photo that really helps in visually dimensioning the amount it represents.
Maine has the "loose thrown cord", and then there are:
>Other non-official terms for firewood volume include standing cord, kitchen cord, running cord, face cord, fencing cord, country cord, long cord, and rick, all subject to local variation.
easily more people die - probably in every leg of this biomass face (logging and transportation are both notoriously accident prone industries, and neither of them are kind to the human body, and flying ash at the place of burning) every year than died due to the Chernobyl disaster.