News for hackers. Stuff that matters.
Re:New atomic clock loses only one second every 300B years by terafo on Sunday February 20, 2022 @02:34AM (#30403955)
I, for one, hope that more research would be put into lowering the cost of atomic clocks, not into precision, so it is possible to put atomic clock into everyday devices.
Re:New atomic clock loses only one second every 300B years by dguest on Sunday February 20, 2022 @04:08AM (#30404345)
Why do we need atomic clocks in everyday devices?

Most everyday devices use quartz resonators, which, with some temperature stabilization, will gain or loose around 25 seconds a year [1]. As others have mentioned the clocks can be synced to other time sources (easily multiple times a day) such that this drift is always far less than a second. This is good enough for most everyday purposes.

You mention in another reply that some companies are installing atomic clocks on servers. As I understand it this is mainly to deal with synchronization across distributed databases. Since most everyday devices aren't actually maintaining these databases they probably make due fine with quartz resonators.

[1]: https://en.wikipedia.org/wiki/Quartz_clock#Accuracy

Re:New atomic clock loses only one second every 300B years by adrian_b on Sunday February 20, 2022 @08:13AM (#30405410)
There is certainly no need to have an atomic clock in each everyday device.

However, when you own one atomic clock, which you can use to calibrate all quartz resonators and many other kinds of devices used for measurement, then that is one less dependency of the outside world.

Some people like to be as independent as possible.

As long as you don't have your own atomic clock, you are dependent of Internet or other communication means and of access to institutions that do have atomic clocks, to synchronize and calibrate your devices.

Re:New atomic clock loses only one second every 300B years by tzs on Sunday February 20, 2022 @10:33AM (#30406483)
In the specific case of timekeeping though what is the point?

For everything that probably 99.9999% of people do that just involves their at-home devices with no outside communications they don't need time more accurate and stable than a quartz resonator. Heck, most people could get by fine at home if all their clocks dropped the seconds display only showing hours and minutes, provided that they also had a stopwatch for when they need to time intervals smaller than a minute.

You generally only need something better when you are coordinating things that do involve communicating with the outside world in which case you can sync with outside clocks.

Re:New atomic clock loses only one second every 300B years by umanwizard on Sunday February 20, 2022 @12:40PM (#30407444)
GPS satellites broadcast time signals; you don’t need Internet access to receive them.

But if you don’t want to be dependent even on GPS, you can apparently buy a small atomic clock for $1500, well within reach of many tech enthusiasts: https://physicsworld.com/a/atomic-clock-is-smallest-on-the-m...

Re:New atomic clock loses only one second every 300B years by sgent on Monday February 21, 2022 @06:43AM (#30414671)
You can buy SDR based GPS receiver (using atomic clocks on satellites) for very cheap. For ~1500 you can buy a 1x PCIe atomic clock and then run a sNTP server to update everything.
Re:New atomic clock loses only one second every 300B years by LASR on Sunday February 20, 2022 @04:27AM (#30404420)
Well it’s for other things than just telling you what time it is.

You could have a GPS that is far more precise. Or a altimeter that detects height changes based on gravitational time-dilation.

There are tons of things you can build on top of precision timing.

The use cases may have nothing to do with time, like in the altimeter case.

Re:New atomic clock loses only one second every 300B years by dguest on Sunday February 20, 2022 @05:31AM (#30404707)
Giving your GPS the ability to calculate gravitational time dilation would be cool.

According to Wikipedia [1] gravitational redshift is about 1e-16 per meter. Someone else posted a clock costing around $2k with a precision of around 1e-11 [2], so, the current commercial clock is giving us the elevation with a precision of around 100km.

To get per-meter resolution we'd need 1e-16 precision, which is on par with the more "standard" clocks in research laboratories and better than the clocks we put on GPS satellites by a few orders of magnitude. Unfortunately that just puts us on par with an existing GPS.

On the other hand, the bleeding-edge optical-lattice based atomic clocks described in this article give us altimeters with mm resolution. So we might actually be reaching the point where atomic clocks would be useful in "everyday devices". All it takes is for someone to shrink a tabletop experiment down to the size of a bar of soap, and to make it work without all the climate control, electromagnetic shielding, and vibration damping that come standard in a state-of-the-art atomic physics lab.

[1]: https://en.wikipedia.org/wiki/Gravitational_redshift

[2]: https://www.sparkfun.com/products/14830

Re:New atomic clock loses only one second every 300B years by Xpol on Sunday February 20, 2022 @02:40AM (#30403978)
They are not mutually exclusive. There're groups that are developing portable atomic clocks, and then we have this group that are pushing the frontiers. While not in everyday devices, cesium/ rubidium clocks which are less accurate but there're already commercial products that are used in observatories around the world. The standard time of your country might already be referenced to one of these.
Re:New atomic clock loses only one second every 300B years by terafo on Sunday February 20, 2022 @03:04AM (#30404094)
Actually, I think spending research time on lowering cost is much more beneficial to accuracy in the long run. It is possible to spend much more on research in case when there are tens of millions of devices produced each year, than in the case when these things cost a couple of grand per PCIe card, which is reasonable cost for servers, but not for consumer devices.
Re:New atomic clock loses only one second every 300B years by fsh on Sunday February 20, 2022 @02:58AM (#30404064)
It is usually much simpler to put a GPS receiver in the device and to make use of the dozens of atomic clocks flying over our heads. Or to use NTP over the internet.
Re:New atomic clock loses only one second every 300B years by terafo on Sunday February 20, 2022 @03:08AM (#30404122)
You can have hundreds of ms of error with these approaches, which is hard to compensate for.
Re:New atomic clock loses only one second every 300B years by Youden on Sunday February 20, 2022 @03:34AM (#30404209)
Hundreds of milliseconds? A receiver like [0] is specced for single-digit nanoseconds. Even the standard-precision modules [1] are double-digit.

My understanding is that GPS wouldn't function if the timing was inaccurate to several hundred milliseconds.

[0]: https://www.u-blox.com/en/product/lea-f9t-module

[1]: https://www.u-blox.com/en/product/neo-m9n-module

Re:New atomic clock loses only one second every 300B years by omegalulw on Sunday February 20, 2022 @03:17AM (#30404159)
With GPS you can measure time with <100ns person.
Re:New atomic clock loses only one second every 300B years by terafo on Sunday February 20, 2022 @03:27AM (#30404189)
You should tell that to meta, since they are putting atomic clocks into each one of their servers, which is, according to you, unnecessary, because same or better result can be achieved by just constantly syncing with GPS.
Re:New atomic clock loses only one second every 300B years by rcxdude on Sunday February 20, 2022 @04:52AM (#30404540)
Usually the reason for including the atomic clock is reliability: the atomic clock can keep good enough time for a short period if the GPS signal is lost. Their time cards still primarily run off of GPS (in fact there are 3 nested clocks in the standard design of these systems: an oven-controlled crystal oscillator which is already quite stable by itself, but more importantly gives a very clean sine wave output, then an atomic clock (usually rubidium) which is more stable but higher noise which is used to tune the crystal oscillator, then the GPS signal which is even more stable with even higher noise used to tune the atomic clock. You can often just skip the atomic clock in the arrangement and you'll get the same performance while you have a GPS signal.)
Re:New atomic clock loses only one second every 300B years by fsh on Sunday February 20, 2022 @03:50AM (#30404266)
The atomic clock on their card performs much worse than the built-in GPS receiver. In normal operation, it serves no real purpose. I guess some bored engineers wanted to have something fun to play with.
Re:New atomic clock loses only one second every 300B years by dxdm on Sunday February 20, 2022 @03:47AM (#30404257)
I think that's a fallacious argument. On the face of it, that they're not using GPS doesn't necessarily mean that it's because of a lack of precision. There could be other factors than precision that influence their choice.
Re:New atomic clock loses only one second every 300B years by 8note on Sunday February 20, 2022 @03:51AM (#30404272)
They're also working on the metaverse, so they've got some weird choices overall. That's it's meta doing it doesn't magically make it the best .

The big weaknesses of GPS are when you're accelerating and way up north or way down south where satellite coverage is poor

Re:New atomic clock loses only one second every 300B years by Youden on Sunday February 20, 2022 @03:47AM (#30404259)
You're assuming that Meta developed the Time Card [0] because GNSS or NTP aren't accurate enough. That's not the case, Meta tells us exactly why they developed it, in the "Why do we need a new time device" section of [0]. TL;DR: openness and software support.

And they're not putting one in every server, they're using it as a reference for their new NTP-based timing protocol [1], with which they showed an uncertainty of only a few hundred microseconds.

[0]: https://engineering.fb.com/2021/08/11/open-source/time-appli...

[1]: https://engineering.fb.com/2020/03/18/production-engineering...

Re:New atomic clock loses only one second every 300B years by fanf2 on Sunday February 20, 2022 @08:00AM (#30405338)
The state of the art is the chip-scale atomic clock https://en.wikipedia.org/wiki/Chip-scale_atomic_clock which came out of a research project at NIST. It is useful for devices that need good accuracy for long holdover times without radio reception. A Microsemi SA.45 CASC retails for around $1500.
Re:New atomic clock loses only one second every 300B years by reshie on Sunday February 20, 2022 @07:43AM (#30405251)
a lot of clocks sync to them. you can get table clocks that do as well.